Part Number: TPSF12C1 Tool/software: Hi,
I am planning to use TPSF12C1 for the DC output of a high power converter.
I have seen a few threads indicating that it is possible and should work with no problem. However, when using the quickstart calculation…
Part Number: TPSF12C3 Tool/software: Hi Experts,
I am looking into the TPSF12C3 active EMI filter. Based on some initial testing, I have been able to achieve good performance. However, one problem that I have run into is the possible INJ pin saturation…
Part Number: TPSF12C1-Q1 Hi,
I downloaded TPSF12C1-Q1 design excel tool. When I change some parameters the graphs are destroyed, and even if I turned the default values they were not fixed. How can I solve this problem?
Thanks.
Part Number: TPSF12C1 Hi team,
Is it correct that the signal is injected on the N side via Cinj and on the L side via Cinj and Cx2?
If correct, I think Cx2 will need a large enough capacity for Cinj.
Is there a guideline for how many times more Cx2 than…
Part Number: TPSF12C1 Hi,
Is there a formula to determine the value of CSEN1/2?
The datasheet uses a 680pF capacitor, but I want to check if I can use a 1000pF capacitor. What happens if the CSEN value increases?
Best Regards,
Nishie
Part Number: TPSF12C1-Q1 Team,
what's the best way to find the common mode impedance to enter in the excel calculation sheet? Does customer need to do a simulation or is there a simpler way?
Best regards
Part Number: TPSF12C1 Hi team,
Where should I insert the injection resistor when using FRA to adjust the loop gain characteristics?
Since the injection is on the N side, I am thinking of inserting an injection resistor between the CSENS2 and SENSE2A/2B…
Part Number: TPSF12C1 Hi team,
Does this device must need 2-stage passive filter? Is it able to use for single stage filter?
I heard it can't, but would like to ask the fact and reason.
Best regards,
Hayashi