Hello Jack,
Thanks for your valuable feedback!!
I have some additional open points listed below:
According to the TI calculator, C49(Cdiv1) and C50(Cdiv2) are calculated to be around 2µF. However, this capacitance results in a delay when turning on…
Part Number: TPSI3050 Tool/software: We are planning to use TPSI305x-Q1 (Driver) and SIR5802DP-T1-RE3 (MOSFET) for our design and A lso,we are going with two wire mode design and below attached schematic snap.kindly check this selected capacitor value…
Part Number: TPSI3050
Tool/software:
Hello,
We are looking for a high voltage ideal diode ( 400V or so) solution ; Can TPSI3050 be used as an idea diode ? If so, how does it need to be configured ?
Does TI offer other solutions for this application at…
Part Number: TPSI3050 Hello ,
I'm utilizing the TPSI3050S to drive a MOSFET in a three-wire configuration. An IR detector is employed for the enable logic, which by default is active, holding the enable pin low. When the light is obstructed, the enable…
Part Number: TPSI3050-Q1 Tool/software: As the title says I am curious about what the idle current draw is from the IC when not enabled but powered on. I am trying to calculate the discharge rate of a battery when the system is in an idle state.
Hello Sv,
Thanks for your reply here.
Sv said: I believe the clamping diode will keep the VDRV pin 2V below the VSSS voltage but not against negative voltage. Please correct me if I am wrong.
VDRV should have body diodes to clamp in the negative direction…
Part Number: TPSI3050 Hello team,
I am trying to use the TPSI3050S to drive the Power MOSFET to control the power supply lines . the expectation for our application is 100% ON.
From the datasheet maximum duty cycle we can obtain is 93% i would like to…
Part Number: TPSI3050-Q1 Other Parts Discussed in Thread: TPSI3050 ,
Tool/software:
Hi Team,
1) I am designing two different MOSFET with TPSI3050 Driver.
We are designing the TPSI3050 in two-wire mode and using a MOSFET. I have calculated the CDIV1 and…
Part Number: TPSI3050 Hi related to my previous post, are there instructions somewhere about how to get the TPSI3050 model into Pspice and set up a simulation? Haven't seen any literature on it. Thanks, Dave
Part Number: TPSI3050-Q1 Other Parts Discussed in Thread: TPSI3050 Hi expert,
Can I know will TPSI3050 suitable to drive an SCR like TN3050H-12GY-TR?
Do you know how to consider the gate drive voltage and how to determine whether the power is enough? I…