Part Number: TPSM365R6 Tool/software: Hello guys,
One of my customers is evaluating TPSM365R6 for their new products.
At this moment, they have the following question. Could you please give me your reply?
Q. When VIN is not apply, can a voltage…
Part Number: TPSM365R6 Other Parts Discussed in Thread: LMR36506 , LM5166 , Tool/software: Need a suggestion quickly on the below requirement.
DC-DC converter with integrated inductor ,with Specifications of 1. 5V output voltage 2. 300mA -500mA output…
Part Number: TPSM365R6 Tool/software: Hello,
I am using the TPSM365R6FRDNR for a PoE application with a set output of 12V.
According to the datasheet (page 40) the temperature raise is very decent for 24VIN, 12VOUT and FSW 2.2Mhz at 0.6A output. …
Part Number: TPSM365R6 Tool/software: Please advise me. Am I correct in understanding that TPSM365R6, TLVM236x5 and similar modules should not be used on 2-layer PCBs?
Part Number: TPSM365R6 Tool/software: Hi,
I have a problem with the TPSM365R6. The 5V output voltage oscillates like on the oscillogram below.
The input voltage range is 12-48V. The oscillograms were done with 25V on the input.
Here is the scheme…
Part Number: TPSM365R6 Tool/software: Hi,
I am using the below schematic:
Up to VIN < 40V the output seems to be stable at 3.3V.
Above VIN = 40V, the IC upon power-up immediately defects resulting in a short-circuite between VIN and VOUT.…
Part Number: TPSM365R6 Tool/software: I'm trying to make a layout symbol for TPSM365 but have some questions about the recommended footprint.
What does the gray and green indicating?
I can’t understand how we should make metal and mask for pin10(GND…
Part Number: TPSM365R6 Tool/software: Hi Ti team,
I don't have much experience on DCDC that doesn't have control-loop compensation tuning.
In TPSM365R6 datasheet it mentions
"Control-loop compensation is not required, reducing design time and…
Part Number: TPSM365R6 Tool/software: Hello,
I was working with the MODE/SYNC version of the part and will not be using the sync function, so was looking for how to tie the pin for FPWM or Auto mode. I see in the datasheet I tie to either of the two…
Part Number: TPSM365R6 I have imported the spice model into LTSpice using the basic .lib (file loclation). However upon running the simulation I get an error stating 'Duplicate definitions for ipkmax_clamp'.
Does anyone know how to resolve this?
