Part Number: TPSM53602 Tool/software: Hello,
I'm trying to simulate the TPSM53602 power module with the following parameters:
Vin = 5 V
Vout = 3.5 V
Iout = 1.5 A
There is no output voltage present, even with a valid input voltage and an EN voltage…
Part Number: TPSM53602 Other Parts Discussed in Thread: TPSM53604 , TPSM33625 , TLVM23625 Hi,
I'm planning on using TPSM53602RDAR. The datasheet clearly states requirements for both input and output capacitance, output capacitance as a function of output…
Part Number: TPSM53602 While I referred datasheetTPSM53602RDAR, as the switching frequency is dependent on the input voltage, output voltage and the load current.
Most probably we might be at 1.4Mhz switching freq in PWM mode for the cases only if we…
Part Number: TPSM53602 Other Parts Discussed in Thread: TPS3702 ,
Hello,
is it possible to use the 5V LDO output to supply three (3) TPS3702 monitor ICs (connected to VDD Pin of TPS3702)?
TPS3702 has a max. VDD current of 12uA each, so total current well…
Part Number: TPSM53602 Is it possible that noise inside TPSM53602 appears on signal from PGOOD pin?
Please refer to attached file. We captured waveform of signal from PGOOD pin, and it is seems that there is impulse noise. TPSM53602 PGOOD noise.pdf
Part Number: TPSM53602 Dear Team,
The customer uses TPSM53602 with a load of 0.1A. They will do the reliablity test before product delivery and force 3A current with TPSM53602 ,about 1 minute. Now customer wants to confirm whether this will cause any adverse…
Part Number: TPSM53602
Is it possible that value of TPSM53602 output current become negative ?
Now, we are evaluating output current and observe such phenomenon. It seems that output current become negative during ramp-up, after ramp-up. Please refer to…
Part Number: TPSM53602 Hello,
I'm trying to simulate a TPSM53602 circuit with PSpice for TI.
Here is my circuit :
I'm trying to do a DC sweep from 10V to 28V. The sweep works but the output voltage is always very small (a few nV instead of 3.3V…
Part Number: TPSM53602 Other Parts Discussed in Thread: ADS1235 , , ADS1261 , LMR33630 Hello
I'm working on a project for a load cell data acquisition using the ADS1235 for data reading. In this scenario i have only the input voltage of 24VDC, then i need…
