Part Number: TPSM63606 Dear Sir:
The card was manufactured and soldered already, but the chips of tpsm63606 are very hot after several minutes? I have used 3 pcs tpsm63606, is it too much?
Part Number: TPSM63606 Hi,
We have a board where two of the TPSM63606 dc dc convertors have caught on fire when the input power was connected.
Input : 18-24V low internal resistance battery
Output of one TPSM63606 : 14.4v
Output of other TPSM63606…
Part Number: TPSM63606 Other Parts Discussed in Thread: LMZ14203H , TLVM13630
Hi ,
1) TPSM63606 can be used as negative buck boost and Can meet 5Vin, -10Vout @ 3Amp as per Data sheet Specs. Please confirm if my understanding is correct
2…
Part Number: TPSM63606 The EN voltage rising threshold is 1.263V.
The EN/SYNC is reference -VOUT ( Figure 9-12. Circuit Schematic in datasheet ) for IBB topology.
Is the RENB calculation using Equation 7 (reference to AGND) still valid?
Need help…
Part Number: TPSM63606 Other Parts Discussed in Thread: TPS564257 I am going to use TPSM63606 and TPS564257.
My customer wants to perfectly disconnect the Vout line with their load by software command.
The (mechnical) power relay could be a solution…
Part Number: TPSM63606 Hi team,
We are considering a power supply that can be changed from 24Vin to 2.4Vout to 8.5Vout.
What should the switching frequency be set to?
Best Regards,
Part Number: TPSM63606 Hello,
In reading through the feedback on the TPSM63606, it states you can connect to VOUT at the desired point of regulation. I was planning on routing the feedback resistors and cap near the device, but then was going to route…
Part Number: TPSM63606 Other Parts Discussed in Thread: TPSM63610 Hi Team,
Our customer is using Cadence software for spice simulation. He needs the PSpice model for TPSM63606 and TPSM63610 devices for doing simulation. According to our customer the…
