Part Number: TPSM63608 Tool/software: Hi team, I am designing a power supply with adjustable voltage outputs. I am targeting IOUT = 0A to 3A and VOUT = 3V to 20V, and i have input power rail of 24V. I have selected the components as per the data sheet…
Part Number: TPSM63608 Tool/software: Hi Team,
RFBT recommendation is 100k as per datasheet.
Is it ok to retain higher resistance value for feedback resistors?
Thanks,
Vidhya
Part Number: TPSM63608 Tool/software: Hi Team,
What is the current limit on RBOOT and CBOOT pins?
Voltage on these pins is specified as max 5.5V in datasheet.
Regards,
Vidhya
Part Number: TPSM63608 Other Parts Discussed in Thread: TPSM63606 , , TPSM63610EVM Tool/software: HI,
There is an EVM for the TPSM63606, are there plans to release an EVM for the TPSM63608?
Best regards,
Hiroshi
Part Number: TPSM63608 Tool/software: Hi, I would like to ask for a second opinion regarding this design we are planning to use the TPSMM63608 as a CC/CV power supply according to your published documents. However, the device only regulates voltage and…
Part Number: TPSM63608 Tool/software: Hi All,
Tried Simulation below circuit & observing different behavior in graph as shown below.
START UP GRAPH:
STEADY STATE GRAPH: Voltage dip observed here but not seen in start-up case. Could anyone…
Part Number: TPSM63608 Tool/software: The layout example shows a connection/component on the SW pin, while the pin(SW) description states the opposite. Can you explain the proper connection for the SW pin?
Part Number: TPSM63608 Hello,
I used TPSM63608 for a new design and i have difficulty to see any output from the device,
The EN pin is powered by 3.3V input,the input voltage is 24V and the desirable output is 12V.
after few tests i have found:…
Part Number: TPSM63608 Other Parts Discussed in Thread: TPSM63610 When i tried to run the sumaltion for 1V8 @ 0.8A , 1MHz it doesnt allow the change in frequency. By default it is in 0.2MHZ.
