The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.
Part Number: TPSM82810 Hello E2E,
I hope all is well. Are there any restrictions on using an RC filter from Vin to EN on the TPSM82810? Are there corner cases that could cause issues if the RC is too big? What about too small?
Related question. Is there…
Part Number: TPSM82810 Hi,
Could you give me advice if anything I need to correct?
The output voltage is only 0.2V, and PG pin measured result is as below.
Derek
Part Number: TPSM82810 Hello TI experts,
my customer asked the difference between TPSM82810 and XPSM82810.
I can see XPSM82810 in product page and datasheet.
in fact I searched TI web site and datasheet, I did not find the contents about the difference…
Part Number: TPSM82810 Hi team,
Could you comment whether the extended land pattern and solder paste design of PIN5 is necessary? Thanks! The PCB layout engineers of my customer have some concern on the clearance between PIN5 & PIN6.
Best regards…
Part Number: TPSM82810 Hello I saw TPSM82810 is still on sampling state after 1y. May i ask you the release date? Will it be available (on mass production) before 2020 end? Thank you.
Other Parts Discussed in Thread: TPSM82810 Hello,
I designed my project with a TPSM82810. Now I have seen, that I have to buy 3000 pieces and that is to much me.
Can somebody give me an alternative with the same properties and the same pinning?
Thank…
Part Number: TPSM82810 Hi folks,
I'm using the TPSM82810 and trying to configure WEBENCH for my design. According to the datasheet I see three options for setting the COMP_FSET resistor to set the compensation but no matter what I se the supply to in…
Part Number: TPSM82810 Hi,
Is there a dimensionally accurate CAD model for TPSM82810? Step files are preferred but I'm sure I can work with others.
The Ultra Librarian page linked from the TPSM82810 Design & Development section indicates that there…
