Hi Ovadia,
The internal FB upper resistor can be changed by mode selection.
I also don't know what the value is.
You can use external FB divider to calculate the discharge time.
Hope you can understand.
Thanks,
Colin
Part Number: TPSM82903 Tool/software: Hi Team,
TPSM82903SISR Please share the LIne and Load regulation details
My application is 4.75V input and Output is 1.1V@3A & 4.75V input and Output is 2.5 V@3A. Please share the details.
Thank you
Part Number: TPSM82903 Tool/software: I have configured a 41.1kΩ resistor with about 5 chip resistors(33k Ω +4.7k Ω +3.3k Ω +100 Ω+100Ω ) for the feedback pin, and connected it to the feedback pin by dividing the voltage with…
Part Number: TPSM82903 Other Parts Discussed in Thread: TPS62903 Tool/software: Hi Team,
Can we use TPSM82903 as an LED driver with the help of SS/TR pin?
In the datasheet of TPS62903 the example is given but not in the datasheet of TPSM82903 .
In addition…
Part Number: TPSM82903 Tool/software: Hello Ti, I am working on a camera sensor. it required -4 volt (negative voltage) w.r.t ground can you suggest some DC DC regulator or solution for it. vout= -4 vot
Vin 1.8 volt Iout = 100mA.
Best regards, abhineet Ra…
Part Number: TPSM82903 Tool/software: Hi Team,
Regarding WEBench Load Transient step size, Shall i enter my Iout custom step size details ?
Below i have mentioned the refrence. This step is staring 3amps and lower side near to 0.25amps. This report…
Part Number: TPSM82903 Tool/software: Hi Team,
Webench startup simulations were carried out, but the results appear to be strange.
Abnormal voltage rises and falls beyond 0.8 ms.
The simulation conditions are as follows.
Are these results correct…
Part Number: TPSM82903 Other Parts Discussed in Thread: TPSM843620 Tool/software: Hi expert,
Is it possible to use TPSM82903 in parallel connection as shown in the attached file ? We would like to design a power supply circuit with the following conditions…
Part Number: TPSM82903
Tool/software:
Hi,
We intend to make an extremely compact 5V module for a nano-scale quad UAV.
Following are the parameters:
Input Voltage
2S LiHV battery 8.4V max
Output Voltage
5V
Output Current
2A nominal, 2.7A max
…