Part Number: TPSM82913 Other Parts Discussed in Thread: TINA-TI Tool/software: Hello,
Need to simulate TPSM82913 but an error comes up when trying to import spice model into TINA-TI using new macro wizard. Is there a TINA-TI model for this part available…
Part Number: TPSM82913 Tool/software: The above illustrates one device application, however the output current is not enough for our application. if we can put two devices output in parallel to get double output current. if yes, please provide the application…
Part Number: TPSM82913 Hi team,
Could you review two schematic as below? Especially, could you review the input and output capacitors? There are concerns that capacitor value cosiderign DC-bias can't meet device recommendation.
Designator…
Part Number: TPSM82913 Other Parts Discussed in Thread: TPS62913
Hi team,
Regarding to IC, RΘjc(top) is from die to top of the package through mold compound.
What is the definition of RΘjc(top) for the module?
RΘjc(ICtop)＋ the thermal resistance…
Part Number: TPSM82913 Hi,
We are using TPSM82913RDUR power module in our design for 12V-3.3V conversion and 12V-5V conversion. We have designed for 1MHz switching frequency. We designed with enable voltage of 3.3V and soft start time of 4.5ms for both…
Part Number: TPSM82913 Hi,
We are using TPSM82913RDUR power module in our design for 12V-3.3V and 12V-5V conversion. We would like to know the usage of S-CONFIG pin. In datasheet the list of operating modes for S-CONFIG pin is given. As per datasheet…
Part Number: TPSM82913 Hello team,
Do you have PSRR data up to 100MHz?
On the datasheet, it is measured only up to 1MHz.
My customer would like to check the PSRR performance.
Best Regards,
Kei Kuwahara
Other Parts Discussed in Thread: TPSM82913 Hello,
I am looking for the footprint for the following component TPSM82913RDUR. I need it to draw it in my Altium software.
have a good day
Part Number: TPSM82913 I would very much like to have an encrypted LTspice model of the TPSM82913 so I can can simulate its performance using the same format and analysis tools that I am doing for my other non-TI supplies.
While I understand that TI…
