Part Number: TPSM863252 Hi,
I am using TPSM863252 to Generate 2.5V from 3.3V. The load current maximum is 0.5A. Circuit is as below,
When 3.3V is turned ON, the output of the IC goes to 2.08V and gets stuck there. In that state if a multimeter is connected…
Part Number: TPSM863252 Other Parts Discussed in Thread: UCD9090-Q1 , Tool/software: I have some DC-DC power regulator needs and I was hoping TI could recommend the best DC-DC non-isolated match. The input will be +5V.
0.88V, 25A, 3%(1%DC accuracy +…
Part Number: TPSM863252 Tool/software: RD would like to get the detailed guidance about the SMT process in the factory.
Could you help to support this document?
Regards
Brian
Part Number: TPSM863252 Other Parts Discussed in Thread: LMZ31704
Tool/software:
While I'm fairly confident that PG pulls/asserts low when power is GOOD (active low logic) , it isn't explicitly stated (unless I'm just missing it) whether PG is active…
Part Number: WEBENCH-POWER-DESIGNER Other Parts Discussed in Thread: TPSM863252 Hi team,
Regarding Webench of TPSM863252, when I click "SIMULATE" tab, it shows "Simulation not enabled for this design".
When will simulation be enabled…
Part Number: TPSM863257 Hi team,
About package, customer have two questions following. Could you support these?
Does the side face of pin 5to7 has conduction points? (same as side face of pin1&2 , 3&4)
Is it necessary to solder the electrodes…