Part Number: TPSM8D6B24 Tool/software: Hi Team,
I have a question regarding the connection between AGND_A (pin 21), AGND_B (pin 27) and Thermal PAD (PGND).
According to the TPSM8D6B24 datasheet, AGND_A (pin 21) and AGND_B (pin 27) should be connected…
Part Number: TPSM8D6B24 Hi All,
I have a question about the OCF for TPSM8D6B24.
(47h) If IOUT_OC_FAULT_RESPONSE's IO_OC_RESP is set to Ignore, will fault detection still occur?
I understand that even though it doesn't respond to faults, fault detection…
Part Number: TPSM8D6B24 Hi All,
I have a question about OVP for TPSM8D6B24.
I applied voltage to VOUT to check OVP.
The waveform below shows the result of slowly applying voltage to VOUT while VIN is input with 12V.
Although voltage is applied…
Part Number: TPSM8D6B24 Tool/software: Hello,
I would like to know the weight of the TPSM8D6B24 power module. Could you please provide the typical or standard weight for this module?
Thank you in advance for your support.
Best regards,
Kanno
Part Number: TPSM8D6B24
Hi expert,
My customer used TPSM8D6B24 to power FGPA. Below is the schematics:
TPSM8D6B24.pdf
The issue is no voltage ouput of this module.They didn't use PMBUS. Is the PMBUS necessary?
Here is the previous discussion…
Part Number: TPSM8D6B24
HI,
I wanted to test the Overvoltage Protection, but I couldn't do it well. Could you tell me about the following?
1.Please tell me the correct way to test the Overvoltage Protection. This time, I connected an external DC…
Part Number: TPSM8D6B24 Tool/software: Hi Expert,
Is there any way to check why TPSM8D6B24 outputs VOUT_A and VOUT_B with 0V?
Here lists what I have checked.
1.Based on the Figure 7-6 in datasheet,
We measured with CNTRL=3.3V, VDD5_OK=4V, PVIN_OK…
Part Number: TPSM8D6B24 Tool/software: I'm considering using this part in a new power supply design and I would like to run it through simulations. I am unfamiliar wit the Pspice for TI software and I'm having trouble setting up and simulating the schematic…
Part Number: TPSM8D6B24 Tool/software: Hi All,
I use the TPSM8D6B24 module to supply voltage and current to our AiP module with T/Rx modes.
When we switch to Tx mode, the Voltage output from TPSM8D6B24 is around 1.8V/ 33A. The output voltage continues…
Part Number: TPSM8D6B24 Tool/software: Hi
Can you help review my customer's excel calculator file and schematics attached below ?
we would like to check if any where we can improve the phase marging and gain margin, and also improve the output ripple…
