Part Number: TPSM8D6C24 Other Parts Discussed in Thread: TPS3842
Tool/software:
Dear Sirs and Madams,
We are considering the TPSM8D6C24 and have a question regarding its behavior on startup.
The current startup waveform is as follows:
-- Red : VIN
…
Part Number: TPSM8D6C24 Tool/software: Dear Sirs and Madams,
We are currently mounting the TPSM8D6C24 on a board and checking its operation.
When the output voltage was set to 800mVdc, the output ripple voltage was observed with an oscilloscope and found…
Hi JH,
TPSM8D6C24 is SOA limited by inductor as the inductor temp rating is lower compared to IC
Here is the temp data from PMbus telemetry and thermal camera
This data collected is on 4ph EVM bench testing
Thank you
Savith
Part Number: TPSM8D6C24 Other Parts Discussed in Thread: TPS546D24A Customers are verifying the TPSM8D6C24 configuration with Fusion Digital Power Designer.
(Substituted with TPS546D24A)
As configure the settings, the Compensation part will change to…
Hi Satoshi
I am closing this on e2e and Lets communicate over email
I didn't find this file on TI web, Is it OK to officially publish and expand?
it is still not published and it is a draft
what would be a good time to connect over webex to discuss…
Part Number: TPSM8D6C24 Hi:
Some questions about the 7.2 Typical Application in the TPSM8D6C24 datasheet are as follows:
Q1: Do AGND and PGND need an external connection?
Q2: If the output voltage is set to 3.3V, the VSEL Resistor Divider Code should be 9…
Part Number: TPSM8D6C24 Other Parts Discussed in Thread: TPSM8S6C24 , TPSM8D6B24 , , TPS546D24A Hi,
TI built powerful excel design tool for TPS546x24A devices. The design tool is in the link as below.
SLURB01 Calculation tool | TI.com
This design tool is…
Part Number: TPSM8D6C24 I have a question regarding Table 6-5 on pages 33-34 of the data sheet.
Many pins are described as "Short to PGND (thermal pad)" in Loop Follower's Pin connection.
I think there is no problem with floating some pins…
Part Number: TPSM8D6C24 Hi TI
I have a request regarding configuring the part number TPSM8D6C24 in offline mode using Fusion Digital Power Designer Version 7.9.1. I don't seem to find the device part number in the GUI. Could you please help me out in…
Part Number: TPSM8D6C24 Hello,
My customer is using TPSM8D6C24MOWR in the two cases below.
Q1. Please tell us the appropriate V-Loop Gain and I-Loop Gain setting values for 2 and 4 Bucks in Case #1 and Case #2, respectively.
Q2. Please tell us how to…