Part Number: TRF7960 Other Parts Discussed in Thread: TRF4140-Q1 Hello,
I would like to know if TI has any analog transceiver IC/ wireless MCU that supports (or can support), ISO 11784/11785 FDX standards. I only see HDX operating in 134.2kHz/sub 1GHz…
Hello Ralph,
Thank you for your reply.
If you look at the scope image, do you believe the amplitude difference and waveform correspond to what the reader expects to get back from the tag?
Regarding your other questions: I don't have a good way of…
Part Number: TRF7960 we are doing one security project with trf7960 rfid transciever.
i done configuration for ISO15693 .
1.what is the minimum data_clck frequecy of SPI to communicates with trf7960 from MCU(dspic30f2010)?
2.I got irq status as…
Part Number: TRF7960 Dear TI engineer,
I was reading the technical document of TRF7960 Section 6.6 and had a little confuse about MOSI and MISO(please see the attached picture circuited by red). I can understand MOSI means data in(reader in), but…
Part Number: TRF7960 Dear colleages, I'm developing a application with TRF7960 and I am applying the ISO15693 protocol. Usually, I can read tags and i haven't problems with collisions. Now, I explain you my two specific problems:
1. I can't read the…
Part Number: TRF7960 I initially posted a question regarding using the TI TRF7960 RFID chip and trying to read/write a Murata RFID tag that is approximately 3.5mm square.
I was having trouble reading the Murata tag presumably because the tag is so small…
Part Number: TRF7960 Other Parts Discussed in Thread: TRF7970A Hi,
Could we have the solutions that NFC could support ISO7816-4? We want use mobilephone to simulate a ISO7816-4 card.
Thanks,
Walsh
Part Number: TRF7960 Hello
I'm having a small range problem using the TRF7960 and the tiny Murata rfid chip (LXMS33HCNG). Is it possible to power the TRF7960 PA only with 5V leaving the rest of the chip powered by 3v3 so that the MCU interface can be…
Part Number: TRF7960 I'm using the TRF7960 EVM GUI to read and write to a tag with Fujitsu MB89R118C. I'm using the test tab and entering commands manually for read multiple block. It can only read 1 block at a time, it does not return the data for multiple…
