Search tips
Showing 61 results View by: Thread Post Sort by
    Answered

  • TS3A5017-Q1: Multiplexing AC Signal

    Resolved
    Part Number: TS3A5017-Q1 Other Parts Discussed in Thread: TMUX4052-Q1 , TMUX2889 , TMUX4051 , MUX36D08 Hi, I want to multiplex nos. of AC Signals. my AC Signal strength is 500mV RMS. Which IC should I use to multiplex the AC Signal. Regards Amit Srivas…
    • Resolved
    • Answered

  • TS3A5017: analog input voltage when part is un-powered

    Resolved
    Part Number: TS3A5017 Hi team, When TS3A5017 VDD get no supply voltage, if the VD, VS voltage goes up to 3.3V, any possible for VD, VS get leakage to VDD? From the datasheet, there shows not possible, since MAX Vs, Vd voltage is 4.6V not VDD + 0.5V. …
    • Resolved
    • Answered

  • TS3A5017: Output state when disabled

    Resolved
    Part Number: TS3A5017 Hi, What is the state of the outputs when ENx inputs are activate (H) ? The specification just indicate OFF, is it open or 0V ? Thanks,
    • Resolved

  • TS3A5017: How much current will burn 2D(9pin) pin？

    TI Thinks Resolved
    Part Number: TS3A5017 Hi Expert, Our customer use TS3A5017PWR. One of their system work unnormal. They found TS3A5017PWR pin 9 has an EOS issue. Could you help check TS3A5017PWR pin 9 and what value of current and voltage can damage this device from the…

  • TS3A5017: TSCA

    TI Thinks Resolved
    Part Number: TS3A5017 daer customer need TS3A5017RSVR SN74LVC2G17DCKR SN74LV244APWR REG710NA-3.3/250\REG710NA-3.3/ TSCA d eclarative information ,please help to provide,thanks in advace
    • Answered

  • RE: SN74LV4052A-Q1: Use for I2C switch

    Resolved
    In theory, this can work. But the on-resistance of 100 Ω is quite a lot. Better use the TS3A5017-Q1 (11 Ω).
    • Answered

  • TS3A5017-Q1: Need 2 channel SPI MUX with driver capability

    Resolved
    Part Number: TS3A5017-Q1 Other Parts Discussed in Thread: TMUX1309-Q1 , SN74LVC125A-Q1 , SN74LVC126A-Q1 Hi Team, My customer need 2 channel SPI MUX to control two SPI flash. But due to their MCU driver capability is small, so they ask MUX+buffer capability…
    • Resolved

  • TS3A5017: analog multiplexer for LDC1612 configuration

    TI Thinks Resolved
    Part Number: TS3A5017 Other Parts Discussed in Thread: LDC1612 , TMUX1208 , MUX36D08 , TMUX1308 , MUX507 , TMUX1209 , SN74CBT3251 , SN74CBTLV3251 , TMUX1308-Q1 analog multiplexer for LDC1612 configuration We want to use the LDC1612 from TI and connect it to 16…

  • TS3A5017: Isolation in Power Done mode

    TI Thinks Resolved
    Part Number: TS3A5017 Hi team, My customer is using TS3A5017 in their design and would like to know if it is OK to keep the select pin (in1 and in2) as well as EN pin high while power down the TS3A5019 V+. Regards, SKLoo
    • Answered

  • SN74LV4052A-Q1: The impact of leakage current to Y0

    Resolved
    Part Number: SN74LV4052A-Q1 Other Parts Discussed in Thread: TS3A5017-Q1 Tool/software: Hi, I want to know the impact of the condition shown below: VCC=0V & input leakage current of Y0=100uA Will it damage the chip or make the chip work abnormally…
    • Resolved

Didn't find what you are looking for? Post a new question.