Part Number: TS3DS10224 Hi There:
I have an application with TS3DS10224 below.USB2.0 signal from CPU to MUX pin INB+/-, after passing through MUX, connect to the USB port.
we couldn't pass the eye-diagram test. For tracing the root cause, We probe the…
Part Number: TS3DS10224 Hi team,
My customer is using our TS3DS10224 for usb2.0 application.
They would like to consult with the layout impedance range of TS3DS10224 in USB2.0 application.
I didn't see it at datasheet. Would you suggest to follow as below…
Part Number: TS3DS10224 Other Parts Discussed in Thread: SN74AXC4T245 For a customer the control inputs to the TS3DS10224 are being driven by an IC that only supplies 1.8V as logic high. The TS3DS10224 datasheet recommends 0.75*VCC as the minimum V IH …
Part Number: TS3DS10224 Can the TS3DS10224 analog mux be used to switch differential NTSC/PAL video?
I have a need to switch differential video and not single ended.
I have two camera systems that use a balun, converting the SE video to Differential,…
Part Number: TS3DS10224 Other Parts Discussed in Thread: DP83869 Hi team,
Does TI have Ethernet switch solution which can be alternative for KSZ9897R?
Regards,
Itoh
Part Number: TS3DS10224 Hi,
I have get some confuse about TS3DS10224.
1. Does the device can support UART/USB switch?
2. If INA+/- and INB+/- are 1.8V level, OUTA+/- and OUTB+/- output level are still 1.8V?
3. If TS3DS10224 can’t use 1.8V level as input signal…
Hi Aakash:
From TS3DS10224 datasheet, IO voltage can be 0 to VCC,. VCC for this device is 3.3v, so 1.8v to 2.4v should work.
But TS3DS10224 is not the product of HSSC product line. You may submit another ticket just about TS3DS10224, so the ticket will…
Part Number: TS3DS10224 Hi team,
As title, is there a way to reduce power consumption of the device excepting turning off VCC? i.e. Can power consumption be lower if ENx pulls low?if so, how much? Thanks!
Best Regards,
Leroy Song
Part Number: TS3DS10224 Hello,
We would like to monitor USB bus signal by someway. I found TS3DS10224.
I assumed 1:2 fan-out mode. USB master is connected to INA+/-. USB slave is connected to OUTA0+/-, Monitor is connected to OUTB0+/- for example.
I t…