Part Number: TS5A3166-Q1 Tool/software: To whom it may concern,
Sections 7.6 (3.3 V Supply), 7.7 (2.5 V Supply) and 7.8 (1.8 V Supply) in "SCDS357A –JULY 2014–REVISED DECEMBER 2014", have different figures for parameters "INO(PWROFF)" and "ICOM(PWROFF…
Part Number: TS5A3166-Q1 Tool/software: Hi,
The actual inrush current of the "TS5A3166QDCKRQ1" on our circuit board is 2.32 A peak. Please see the waveform in the link below.
The total inrush power is approximately 16.6 µW. Could you please confirm…
Part Number: TS5A3166-Q1 Other Parts Discussed in Thread: TS5A3166 , , TS5A3167 Hi,
I don't know if it is a mistake but the pin name NO description is Normally closed
And if we look further in the datasheet we have this function table
I know…
Part Number: TS5A3166-Q1 Hi Experts
I am trying to verify the Input leakage current spec in the datasheet.
I am applying 5.5V to the V+ supply pin and then sending +5.5V and/or 0V to IN (pin 4).
I see leakage of 89nA at V_IN = 5.5V, and 123nA with…
Part Number: TS5A3166-Q1 Other Parts Discussed in Thread: TS5A3166 , In the process of selecting an analog switch for my application, I found TS5A3166 and TS5A3166-Q1. While most of its descriptions match TS5A3166, on page 3 of the datasheet of TS5A3166…
Part Number: TS5A3166-Q1 Other Parts Discussed in Thread: TS5A3166 Hi All,
in the Ds of TS5A3166-Q1 there is a YZP package but the part seem not to be available is that correct?
Best Regards,
D.
Part Number: TS5A3166-Q1 Hi Team,
There is a confusing explanation about the ONOFF logic in its datasheet, so please check it just in case.
Is "NO to COM" path shorted when high logic is applied to IN pin? Or Open？
I can find following table on…
Part Number: TS5A3166-Q1 Other Parts Discussed in Thread: THVD1419 , SN74CB3Q3306A , SN3257-Q1 Hi All,
I'm planning to design a system with RS485 transceiver (THVD1419), and want feature of turning ON/OFF the termination through micro-controller.…
Part Number: TS5A3166-Q1 Customer would like to know how many of the transistors inside the design? It’s for the FMEA calculation in motor Safety Functionality . Pls help to support this! Thanks!
