Part Number: TSC2007-Q1 Tool/software: Hi, TI expert
There is an inquiry from a customer to recommend a replacement product due to a touch operation error in TSC2007-Q1.
The current touch operation problems of TSC2007-Q1 are as follows.
[Problem]
1) …
Part Number: TSC2007 Hi Guys! I'm using an open source navigation system for gliders ( www.openvario.de ) which is based on a cubieboard 2. Some of these navigation systems using a resistive touch panel, because they are very cheap and not to sensitive…
You can try the below.
Remove the touchscreen connections. Take a DC Power supply and connect its output through a 470 ohm resistor to X+ pin.
Take a second DC Supply and connect it with 470 ohm resistor to y+
Fix the Y+Voltage to 1.65v DC. Then shift…
Part Number: TSC2007-Q1 Tool/software:
I have located a curious old manual, which Phil Wright asked about in a post 6 years ago.
Phil Wright:
I am trying to obtain a 1977 TI publication entitled, "TMS 1976 Capacitive Touch Keyboard Interface Manual…
Part Number: TSC2007 Dear Texas Instruments Support Team,
I am using the TSC2007 touch controller with an STM32F429IIT6 microcontroller. I have obtained a library for the TSC2007 from Adafruit's website, but it appears to have limited functionality and…
Part Number: TSC2007 Hello all, In a similar case, does it possible work with this device without any connection on A0 and A1?
if i leave open this pins, maybe does it possible disable this address by any command by I2C?
Part Number: TSC2013-Q1 Other Parts Discussed in Thread: TSC2007 ,
Hi,
what are the software changes need to implement in migrating from TSC2007 to TSC2013-Q1, is their any document for the same?
Regards,
Part Number: TSC2007 Hi team,
Normally when touching the panel, PENIRQ will output low and when untouch the panel PENIRQ will return to high.
However, when reading the X,Y, Z1, Z2 data through I2C, PENIRQ output low without touch to the panel, and the…