Part Number: TSC2017 Hi all,
I would like to know the conditions for the PENIRQ Pin goes to Low.
I understand that one condition is when the panel is touched.
What conditions will it be forced to Low?
Best Regards,
Ryusuke
Part Number: TSC2017 Hi all.
My customer conducted an electrostatic test on the touch-panel of a product designed using TSC2017.
Then, the following 2 phenomena occured.
1) PENIRQ pin doesn't output High. It doesn't recover even if input a signal…
Part Number: TSC2017 Other Parts Discussed in Thread: STRIKE Hi all,
I would like to know test method based on IEC 61000-4-2.
My customer ran ESD test of ±8kV in-air discharge on the finished product.
As a results, the touch screen froze.
I would…
Part Number: TSC2017 When Vdd = 0V, the voltage range that can be input to the C1 (SDA) and D1 (SCL) pins is -0.3V to Vdd+0.3V, or ±0.3V, is this correct? If I were to pull up with an external 3.3V, would the semiconductors be damaged?
Part Number: TSC2017 When Vdd = 0V, the voltage range that can be input to the C1 (SDA) and D1 (SCL) pins is from -0.3V to Vdd+0.3V, or ±0.3V, is this correct?
If I were to pull up with an external 3.3V, would the semiconductors be damaged?
Part Number: TSC2017 Hi all,
I would like to know the results of IEC61400-4-2.
Which of a) to c) does it apply?
a) The device works normally when the voltage of the target is applied.
b) The device malfunctions, but it does not stop working…
Part Number: TSC2017 Hi TI expert,
It seems that TSC2017 don't give the ACK feedback signal, could you please help analysis the possible cause of the issue? For more detail information, you can contact me through email.
B R,
Jayce Luo
