Part Number: TSW3085EVM Tool/software: I send a sine tone to the TSW3085EVM from the FPGA at a fixed frequency and I can see it in the spectrum. Then I change the QMC settings to eliminate the image of the sine wave and the image disappears. After these…
Part Number: TSW3085EVM Tool/software: Hi TI Forum,
I have problems when my FPGA output data rate is 48MSPS and my DAC interpolation is x16, but I don't encounter any problems with the spectrum when the data rate is 96MSPS and my DAC interpolation is…
Part Number: TSW3085EVM Tool/software: My system is working with 1250MHz Fdac, 312.5MHz Ffpga. I am generating 312.5 MSPS 20MHz sine signal from FPGA. LO frequency is 1GHz. I am in single sync source mode and NCO is off. I am using ZCU102 as FPGA.
I…
Part Number: TSW3085EVM
Hi,
This is related to my previous topic... and it is highly appreciated if anyone can look into my case and advise.
I just ordered and received TSW1400EVM + TSW3085EVM to repeat and evaluate ACP performance. But the DAC…
Hello,
I can only describe the high level setup that you will have to configure yourself. You will have to work with the clocking team (forum) offline to set your own LMK04800 setting
1. you need to adjust the PLL loop 1 to still accept the 61.44MHz…
Part Number: TSW3085EVM
I have a question about using this platform. I send samples WCDMA signal with 614.4Mhz sampling. on tsw308x I start from the Regs of the User's Guide of the TSW308x Evaluation Module with the NCO and QMC disabled. I do this so…
Hi Jim,
I'd like to get my hands the TSW3085EVM and the TSW1400, (as the TSW3100 seem obsolete). This would give me a clean LTE signal source. It would have been nice if it could actually measure %EVM as implied.
Maybe it is time to update the manuals…
Hi KH.
Thanks for the reply.
Actually, our test configuration is TSW1400(pattern gen.)+ TSW3085EVM+ TSW3482EVM .
And DATACLK and FRAME signal will be shared between 3085 and 3482.
Is it ok? and we are going to make custorm adapter board.
Pleas…
Hi
i want to create a 4 Mhz-bandwith signal at 2.672 GHz .In the High speed converter i create this tones. I apply a LO at 2.1672 Mhz When i load in the 3085 GUI the file
DAC34821228p8MHz_2xInt_NCO_30 Mhz_single_sync_source_mode
and send, i can…
You can still use the DAC3484 but with a IQ modulator to mix up to 6GHz. Try this platform to meet your low consumption power needs.
www.ti.com/.../TSW3085EVM
Yusuf
