• USB-C-PD-DUO-EVM: Has anyone found the mating (male?) connector for this weird-o Foxcon connector

  

  Andrew Ward

  TI Thinks Resolved

  Part Number: USB-C-PD-DUO-EVM OK.. Here are the Spec sheets for the Connector on the EVM. But I can't find the raw Plug end anywhere Does anyone have any leads? 8228.JPD1135-509-7F.pdf 8037.DC-PowerJack-JPD1135-509-7F-FOXCONN-JPD1135-509-7F…

  • over 3 years ago
  • Power management
  • Power management forum

• DRV8256PEVM: DRV8256PEVM has incorrect IC(P3DRV8436) in EVM board.

  

  freda li

  TI Thinks Resolved

  Part Number: DRV8256PEVM Other Parts Discussed in Thread: DRV8436 , , DRV8436E DRV8256PEVM board is mounted a wrong IC DRV8436. Meanwhile, this DRV8436 is P3DRV8436, not DRV8436P. DRV8436E could not match DRV8256P pin definition. So, this DRV8256PEVM…

  • over 4 years ago
  • Motor drivers
  • Motor drivers forum
Answered

• LM5155EVM-SEPIC: The EVM board has ringing

  

  Arkady Ler

  Resolved

  Part Number: LM5155EVM-SEPIC Other Parts Discussed in Thread: LM5155 Hi, I've loaded the LM5155EVM-SEPIC with 10 ohm load. Vin 17v. Switching frequency 2.14MHz I'm observing very large ringing on: Output diode's anode FET's drain The…

  • Resolved

  • over 4 years ago
  • Power management
  • Power management forum

• MMWCAS-RF-EVM: Mmwcas-rf-evm module has two antenna problems, customer demand: replacement or maintenance

  

  Betty Liu1

  TI Thinks Resolved

  Part Number: MMWCAS-RF-EVM T01097016 The mmwcas-rf-evm module purchased 1pcs and found that there were two antennas with problems. At first, the two antennas worked normally. After a period of follow-up use, the two antennas had problems. According to…

  • over 5 years ago
  • Sensors
  • Sensors forum

• TSW1400EVM: Why TSW1400 EVM has a limit of 10sec?

  

  LIU

  TI Thinks Resolved

  Part Number: TSW1400EVM Other Parts Discussed in Thread: DCA1000EVM I guess that, compare to DCA1000, which t ransfers the collected data back to the PC, TSW1400 can only save the raw data in the on board memory. But why 10 sec?

  • over 4 years ago
  • Data converters
  • Data converters forum

• ADS1256: ADS1256 the ACD pro has error as "EVM/HW Incompatible"

  

  THIAGARAJA VINAYAGAM

  Part Number: ADS1256 ADS1256: ADS1256 Reset issue Hi Sir I am using the ADS 1256 module connected with SPI port. Using the ADS1256 the ACD pro has error as "EVM/HW Incompatible" Please advice . Thanks and regards Thiagu

  • over 4 years ago
  • Data converters
  • Data converters forum

• AWR2243: Has any CND FD interface offered on MMWCAS-RF-EVM ?

  

  ?? ?

  TI Thinks Resolved

  Part Number: AWR2243 Other Parts Discussed in Thread: MMWCAS-RF-EVM Has any CND FD interface offered on MMWCAS-RF-EVM ?

  • over 4 years ago
  • Sensors
  • Sensors forum
Answered

• LMX2581EVM: EVM has a chassis

  

  Danilo A.

  Resolved

  Part Number: LMX2581EVM Hi Team, A customer wants to know if the LMX2581EVM Evaluation Module has a chassis. Regards, Danilo

  • Resolved

  • over 5 years ago
  • Clock & timing
  • Clock & timing forum
Answered

• BQ76952EVM: The EVM has been broken down and I need possible causes.

  

  Junkichi Sugita

  Resolved

  Part Number: BQ76952EVM Other Parts Discussed in Thread: BQ76952 , I connected the evm with a real 16s Li-ion battery. Since I wanted to charge or discharge with around 10A, I prepared CFET and DFET connected in series outside the EVM, removing Q7,…

  • Resolved

  • over 5 years ago
  • Power management
  • Power management forum

• IWR6843ISK-ODS: EVM has stop being able to be programmed

  

  Chris Lande

  TI Thinks Resolved

  Part Number: IWR6843ISK-ODS Other Parts Discussed in Thread: MMWAVEICBOOST Support, I have been suing the IWR6843ISK-ODS for some time now. Recently I'm unable to program the EVM. I believe the setup is correct. I have attached a number of image details…

  • over 5 years ago
  • Sensors
  • Sensors forum

Didn't find what you are looking for? Post a new question.