Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: TUSB546-DCI Tool/software: Dear support team,
We had a technical question about the attached document obtained from the website
https://www.ti.com/product/TUSB546-DCI
This document also lists an element called Type-C PD Controller for this…
Part Number: TUSB546-DCI Other Parts Discussed in Thread: TUSB546A-DCI , TUSB1046-DCI , TUSB1046A-DCI , TUSB1146
Tool/software:
TUSB546-DCI has three sets of equalization (EQ), what is the difference among DPEQ, EQ, and SSEQ?
Part Number: TUSB546-DCI Hi Team,
Could you possible help to check for below AUXP/N and DP data AC capacitor and pull up/down resistor position in layout design? Should customer put the AC capacitor and pull up/down resistor near to our device or near…
Part Number: TUSB546-DCI Hi team，
I have a question to ask:
The DP signal line from the GPU to the MUX on the board is 85Ω, but the RX and TX from the MUX to Type-C require 90Ω in the Layout Guidelines.
How far do we actually have to go?
…
Part Number: TUSB546-DCI Hi team,
TUSB546-DCI Schematic Checklist(SLLA400) recommends 220nF in Table.1 specifically.
While, Table8-1 of the datasheet shows "AC-coupling capacitor (75 nF to 265 nF)".
Is 220nF must requirement? Or it's no problem…
Part Number: TUSB546-DCI Other Parts Discussed in Thread: TPS25750 , Hi everyone!
I´m use redriver mux TUSB546 and need to control with TPS25750, so, I would like to know how or with which pins I can control the mux redriver with Power Delivery?
So…
Part Number: TUSB546-DCI Hi Team,
Our customer is using the TUSB546I-DCI.
We have some problems:
1. When TUSB546 detects that the device is plugged in, CC1 is configured as high or CC2 is configured as high?
2. Whether the device is plugged in or not…
Part Number: TUSB546-DCI Dear Expert
Tusb546 chooses 2+2lane mode, the SS communication of USB3.0 cannot work (only USB2.0 could communication) .
The speed is always only 40MBps, and the speed of direct connection to the computer can reach 110MBps (the…
Part Number: TUSB546-DCI I'm looking at replacing a Parade PS8740B USB-C re-driver with the TUSB546 re-driver. The Parade chip is used on a Cypress CCG3 USB-C design. The CCG3 controls the Parade chip via I2C. I2C control seems to be pretty common…
