Part Number: TUSS4470 Hi Team,
Posting on behalf of our customer.
I have a question regarding the frequency range that the TUSS4470 and its evaluation board can support and drive.
My goal is to drive an external ultrasonic transducer with a center…
Part Number: TUSS4470 Tool/software: Hi, I am trying to interface the TUSS4470 with i.MX93 via SPI ports. I tested the SPI in loopback and logic, the SPI configuration is ok, and it was also confirmed by the i.MX93 vendor. I want to read the TUSS4470…
Part Number: TUSS4470 Tool/software: Hi, I am interfacing TUSS4470 with an IMX93 SOC. it there a device driver or similar driver for the TUSS4470? BR Basel
Part Number: TUSS4470 Hi Experts,
I need help with the Device ID.
The datasheet shows 0xB9.
But the customer is reading 0x3B .
Regi address = 0x1D = 00011101 Shift once left = 00111010 Insert read bit (1) = 10111010 Insert the polarity bit …
Part Number: BOOSTXL-TUSS4470 Other Parts Discussed in Thread: TUSS4470 , MSP-EXP430F5529LP , ENERGIA Tool/software: Dear Team,
MSP-EXP430F5529LP and BOOSTXL-TUSS4470 EVM and we successfully tested the board using "TUSS4470 EVM GUI". We need to make…
Part Number: TUSS4470 Application: Detect electrolyte level inside a NiCd battery cell using an OD 3mm x 7mm axial cylinder piezoelectric sensor with an average K33 of 0.73, average serial resonance frequency (fs) of 174.28 kHz, parallel resonance (fp…
Part Number: TUSS4470 Hi Experts,
I need help with the use case below.
My transducer uses a shielded two-conductor cable with one signal wire and one ground wire, and I want to make sure I'm adapting it to the differential interface correctly. Here…
Part Number: BOOSTXL-TUSS4470 Other Parts Discussed in Thread: TUSS4470 Tool/software: I have a problem with the TUSS4470 Development board. First of all, I was able to read the distance through the GUI by making the correct settings with a 40Khz transducer…
Part Number: TUSS4470 Other Parts Discussed in Thread: THS4551 , ADS127L01 , ADS127L11 , ADS1261 , ADS1262 , ADS131M04 , ADS131M02 , PGA460 Hello TI team,
I am building an industrial ultrasonic level probe to measure electrolyte height inside an aircraft…
Part Number: TUSS4470
Hello,
I'm currently experiencing EMC immunity issues with the TUSS4470.
During noise injection testing, we observed interference at the TUSS4470 driver's INN and INP pins. The noise injection is according to UNE-EN IEC…
