Part Number: UCC14141-Q1 Hello,
I need the spice drawing to simulate what the different modes of operation will look for the UCC14141-Q1 component. I see that there is a Tina file, but I need the spice file for my application. Please let me know if…
Part Number: UCC14141-Q1 Hi I am testing my new board for traction inverter. My input is 12 V, both pg and enable pin are pulled to high by default. But i am not getting any output at secondary. Configuration is VCC-VEE 20V & GND-VEE as 5V. Qg=3.9uC.…
Part Number: UCC14141-Q1 Tool/software: The power-good (PG) pin is an open-drain output that indicates (short) when the module has no fault and the output voltages are within ±10% of the output voltage regulation setpoints.
i will be using 3 phases…
Part Number: UCC14141-Q1-CALC Other Parts Discussed in Thread: UCC14141-Q1 Hi,
I here by request you to provide the SPICE model for UCC14141-Q1 to conduct the LTspice simulation. I only find simplis model available for the part. Kindly do the needful…
Part Number: UCC14141-Q1 Tool/software: Hi, We are using UCC14141-Q1 IC we have observed 0.75 W loss in the UCC14141-Q1 excel calculator for our design, Please respond for the below issues.
1. At ambient temp=25 degrees UCC1414-Q1 IC absorbed 100…
Part Number: UCC14141-Q1 Other Parts Discussed in Thread: UCC34141-Q1 , UCC35131-Q1 Hi,
Could TI please share when additional samples will be available for UCC34141-Q1 and/or UCC35131-Q1, along with RTM / general availability? I was referred to E2E…
Part Number: UCC14141EVM-068 Other Parts Discussed in Thread: UCC14141-Q1 Hello,
I need the spice drawing to simulate what the different modes of operation will look for the UCC14141-Q1 component. I see that there is a Tina file, but I need the spice…
Part Number: UCC14141-Q1 Tool/software: Hello,
I have an application when I need an isolated DC-DC converter for 15V - 12V conversion at an output power of ~1.5W. With a 10% safety factor, that becomes 1.65W. As per the datasheet of the UCC14141, at…
Part Number: UCC14141-Q1 Other Parts Discussed in Thread: UCC5880-Q1 Tool/software: I have a question about UCC14141-Q1 circuit design.
When Rg = 1 ohm, Vgate_on = 18V, and fsw = 10 kHz are applied to the gate driver circuit, the peak current (Ipeak_current…
I will address the three questions from your quoted text below:
Prathik P said: My first question is regarding the asymmetrical decoupling capacitances. Per the spreadsheet, the positive rail must be decoupled to ground using a 10uF capacitor, but the…
