Part Number: UCC21540
Tool/software:
Hello experts,
I am Erick, sales in Taiwan, I would like to kindly request for your help with analyze or give me any feedback if there could be any risk to put UCC21540 in immersion cooling.
The immersion cooling…
Part Number: UCC21540 Hello,
I am using the UCC21540DW driver for boost converter to drive top side cooling SIC fets.
The fets have 2 ohm gate resistor inside them.
Can i remove the external gate resistors (to make the layout more effective and small)…
Part Number: UCC21540 Other Parts Discussed in Thread: UCC21222 Hello,
is it ok to place wires in the layout in the bottom layer in the middle of the IC pads and to minimize a little bit the creepage distance of the isolation pads?
Thank you
Part Number: UCC21540 Hello,
I am using the UCC21540DW gate driver for boost converter.
My question is if it is ok to connect the outputs of the fet drivers (OUTA,OUTB) directly to the fets and not to place a series resistors?
The IC will not damage by…
Part Number: UCC21540 Hi team,
I see that the UCC21540 can be used for two low side drivers, two high-side drivers, or a half-bridge driver? So can 2 driver in one UCC21540 be used to drive 2 parallel mosfet if 1 gate driver is not enough? Or more parallel…
Part Number: UCC21540-Q1 Hi Team
In DS, INA/INB transient to GND can reach to -2V@200ns. the worst situation of DIS input customer tested in their system reach to -1.44V @ 20ns. I wanna confirm if DIS has the same feature like INA/INA to withstand this…
Part Number: UCC21540 Hi,
what is the minimum deadtime possible with the integrated deadtime generator? We need about 20 to 80ns - is this feasible with this part?
If this is possible, what would the part to part tolerance on deadtime be?
Other parts…
Part Number: UCC21540 We plan to use this part UCC21540 in our IGBT Gate Drive Design . And I am requesting the IBIS model to simulate the switching event.
Thanks.
Jianhua
