Part Number: UCC21710 Other Parts Discussed in Thread: UCC21732 Tool/software: Hi,
I was looking at the evm and it has a 10kohm gate pull down resistor.
Do we need external gate pull down resistor if the internal miller clamp feature is available for…
Part Number: UCC21710-Q1 Tool/software:
HOW TO CALCULATE THE VALUE OF THE SHUNT RESISTANCE IN THE BELOW SCHEMATIC (R2 AND R14) FOR FAULT SIGNAL DUAL SIC-RS485 DRIVER-(15A)_R006.pdf
Part Number: UCC21710 Hello, we are using the UCC21710 (and UCC21737, but basically it should be the same for this question) with very small resistors for turning on and off - around 0.1 to 0.4 Ohm. As the internal turn on and turn off MOSFETs are given…
Part Number: UCC21710 Hello ,
We are facing a wierd issue with out NTC temperature circuit.
When ever the MOSFET is switching we seem to be getting an accurate reading , but the moment the mosfet stops switching we see an offset being added to the reading…
Part Number: UCC21710 Hi expert
Does the driver UCC21710 tolerate the voltage on pin OUTH, OUTL and CLMPI if the driver is unpowered? Please see attachment for more details about our application.
Thanks. TI driver UCC21710 unpowered questions.pdf
Hi Ganesh,
If you have any feedback, please reply to this thread. I have made a few edits and here is an updated version: 2477.UCC21750.lib
Best regards,
Sean
Part Number: UCC21710-Q1 Other Parts Discussed in Thread: UCC21710 , Hello Team,
I am planning to use UCC21710 in one of my project. I am having few queries related Over current pin of UCC21710-Q1.
I have gone through datasheet of UCC21710-q1 IC. It is…
Part Number: UCC21710-Q1 Other Parts Discussed in Thread: UCC21710 Hi
This is Reza. I am a Ph.D student at University of Maryland at College Park. I do have following design questions about the TI's impressive gate drivers UCC21710, UCC21717 and UCC21755…
Part Number: UCC21710-Q1 Other Parts Discussed in Thread: UCC21710
HOW TO CALCULATE THE VALUE OF THE SHUNT RESISTANCE IN THE BELOW SCHEMATIC (R2 AND R14)
Part Number: UCC21710 Hello experts,
Whether miller clamp protection feature having any role, if the mosfet is turned off using negative voltage ?
Regards
Anoop kumar