Part Number: UCC21756-Q1 Other Parts Discussed in Thread: UCC21732 Hi,
I refer to your document, module and gate driver compatibility
https://www.ti.com/lit/ug/sluuck0/sluuck0.pdf?ts=1707984265782&ref_url=https%253A%252F%252Fwww.ti.com%252Fproduct%252F…
Part Number: UCC21750-Q1 Other Parts Discussed in Thread: UCC21750 We are using UCC21750-Q1 ( https://www.ti.com/lit/zip/slum718 ) as a Gate Driver in our application and are running the simulations in Ansys for checking the EMI/EMC.
However, upon importing…
Part Number: UCC21750 I'm in the process of designing a gate driver, and I have a quick question.
1- Should we use typical values for "detection threshold" and "capacitor charge current" from the technical document?
Please correct…
Part Number: UCC21750 Hi TI-Team,
I am observing a problem during double pulse tests with the driver. When I try to characterize a SiC MOSFET at certain operating points, after turn-on for the second pulse, the gate-source voltage is pulled down to turn…
Part Number: UCC21750-Q1 Hi team,
Do we have life time testing data of UCC21750-Q1? You can email to me if it is internally only. We have NDA with my customer. Are we showing TDDB curve on this feature?
Zoe-yang@ti.com
Part Number: UCC21750-Q1 Other Parts Discussed in Thread: UCC21750 Dear team,
As in attached capture, Vge is only 12.3V at the beginning of the driving signal is active high. And when current is still ramping up, there is a great drop off on the VGE and…
Part Number: UCC21750 Other Parts Discussed in Thread: UCC5350 , UCC5390 Hi expert,
My customer is interested in UCC21750, but their application required a really fast response timing.
They were reading the datasheet and found that theres a feature called…
Hi,
The waveforms look a lot better and clearly show the gate driver short circuit protection is being triggered. As mentioned before there are some slight differences between the performance of high side and low side driver due to board design(gate…
Part Number: UCC21750 Hello,
UCC21750 needs \RST/EN signal to reset the fault output. For my application, we can not provide
a signal from the processor to meet this needs. I could add a timer delay after FAULT happens to reset
it, however this adds possibility…