Part Number: UCC21750-Q1 Other Parts Discussed in Thread: UCC21750 Tool/software: Hi~
Please tell me the required current for the gate input terminal of UCC21750-Q1
Part Number: UCC21750-Q1 Tool/software: Hello
I intend to use the above in my new Designs for SiC MOSFET's and IGBT's.
A few Q's, if you will.
1. Is there any functional difference between -Q1 and without, except
being the former being Automotive…
Part Number: UCC21750-Q1 Tool/software: Hello
I intend to use this Driver for driving SiC MOSFETs for our EV Charger Project.
My Q is when is the internal Miller Clamp active, whenever the Gate Voltage is below
Vclamp; irrespective of whether it is Normal…
Part Number: UCC21750 Other Parts Discussed in Thread: TXS0108E-Q1 Tool/software: Hello,
We are now using UCC21750 for driving. Primary side we use 5V power supply, and all the signal pins (IN+, IN-, RDY, FLT, RST) are driven by voltage level chip TXS0108E…
Part Number: UCC21750-Q1 Tool/software: Hi team,
My customer performed open and short cases on VCC pin of UCC21750-Q1. Would like to check with you the behavior to make sure it is aligned with device logic.
PS: VCC not share the same supply with pull…
Part Number: UCC21750-Q1 Other Parts Discussed in Thread: UCC21738-Q1 , Tool/software: Hi team,
May you kindly share the difference between UCC21750-Q1 and UCC21738-Q1?
Thanks!
Ethan Wen
Part Number: UCC21750-Q1 Tool/software:
Sr.no.
UCC21750DWR
1
UCC21750-Schematic and Layout Recommendation
2
Also clear Capacitor value of input & output Power Supply Before capcitor Byp1 & Byp2 enclosed data sheet of power supply using…
Part Number: UCC21750-Q1 Tool/software: Hi,
Will there be any concerns if the chip is reset during every cycle?
Design Scenario:
I have tied the drive input to the reset pin of the driver.
As the chip resets during a rising edge on the RST pin (after…
Part Number: UCC21750-Q1 Here is the pinout of the IC (UCC21750-Q1):
Is it recommended to keep the 'APWM' pin16 floating if unused or advisable to connect to GND (pin9) ?
AIN pin is tied to COM.
Is there any issue in providing a strong pull…
Part Number: UCC21750-Q1 Other Parts Discussed in Thread: UCC21750 , ISO5452 Tool/software: dear \sir,
i am using ISO5852-Q and want replace to UCC21750-Q1 only difference AIN pin1 connect with COM and pin16 APWM connect with VEE (-8v supply ) can keep…
