Part Number: UCC24636 I recently used webench to create an "mains" ac to 5v dc isolated converter (see https://webench.ti.com/appinfo/webench/scripts/SDP.cgi?ID=829567FEA10E90C3)
i noticed that the output has a resister Rpl between 5v+ and …
Part Number: UCC24636 We are trying to design a power generator circuit using the UCC24636 IC. The encrypted spice models available online are giving simulation error of "too few nodes" in LTSpice. Can anyone provide the unencrypted spice model file for…
Part Number: UCC24636 Dear Expert
My customer start up synchronous rectifier burning MOS DS Pin . This kind of failure phenomenon has about 4 sets, a total batch 500 sets.
Below is schemeitc :
Could you give any suggestion how we locate where the problem…
Part Number: UCC24636 Our customer found folloing SR timing delay waveform. (delay time: about 550ns)
<Condition>
IN:DC240V-DC340V
OUT:13.5V/4A
Also they didn't found low Vin and light load condition.
CH1:Primary FET_VDS
CH2…
Part Number: UCC24636
Our customer consider to use UCC24636 with Low-Side SR Configuration.
Please see attched waveform. 2541.waveform.xlsx
1.Is this waveform normal .?
2.Can they extend DRV ON time ? Please let us know how to extend DRV ON time.
3.If…
Ulrich-san
Thank you for your support.We got additinal information from customer.
Customer checked pcb connections is true.
And capacitor value between VPC to device GND in all sheet are correct
About turns ratio of the windings:
Np:17
Ns:5
Nb:2
Regards…
Part Number: UCC24636 Other Parts Discussed in Thread: UCC28740 , TL431 Dear officer,
I am writing to ask one question about a UCC24636 application in a flyback convert. When I plug in 80-160VDC in, 120V 1A out into WEBENCH, it provides me this circuit…
Part Number: UCC24636 Hi Sir:
I use the ucc24636 as auxiliary power controller, Vout =12V.. And I use the excel UCC24636-Calc to set the external resistance. I have a resistor Q1 in parallel and Q1 is 1200V MOSFET. it Out of work,The Vout i can get 12V…
Hi Charles,
The UCC28781 or UCC28782 could work for this. For the PFC, the UCC28056 can be used on the front end.
I found PMP22538 which is a 60-W reference design that might be a good starting point as well.
WEBENCH recommends an LLC approach which would…
Part Number: UCC24636 Other Parts Discussed in Thread: UCC24624 Dear Team,
our customer uses the UCC24636 for an industrial battery charger. The first version had an output voltage of 11-15.6V, so no problem.
In another project they are looking for a SR…