A list of schematic review templates for many of our devices are available below! These templates are meant to be used in conjunction with our datasheets to help designers review their schematics.
UCC27516 and UCC27517 Schematic Review Template
…
Hello Jacky,
Thanks for reaching out us, my name is Mamadou Diallo from the High Power Drivers team.
From my understanding, you're looking for IC that can convert a 3.3V PWM signal to a 12PWM signal at a 1kHz to 10kHz frequency. Please correct me…
Hello Tim,
Thank you for your response. Of course I can.
Please, do not forget that Vin is a 24 V +- 10% battery, the output is 12 V. The buck converter is supposed to feed a TI UCC27511 MOSFET Driver, which requires a 4A peak current.
Driver_Vsupply…
Hello Eggsy,
For a 48V input converter most designers do use 100V-120V Half Bridge drivers such as the UCC27211A, UCC27201A, and LM5101A to drive both the high side and low side Mosfets.
I can make recommendations for the separate drivers as you request…
Alexey,
A couple of single output low-side drivers to look into are LM5114 and UCC27511. These should be able to handle the higher frequencies. If you really need more output drive current than these offer, look into using UCC27525, which is a dual…
Hi Robin,
TIDA-00173 does use a clever cascode topology for switching very large voltages, but with a unipolar DC bus. With a bipolar AC waveform, this kind of cascode topology does not work very well, since the current into the zener diode gate clamp…
Hi Rogers,
Thanks for reaching out on E2E!
Please see the following feedback:
IN: Input looks good. If there is a lot of noise on your input waveforms, consider adding an RC filter with a TC of no greater than 20 ns.
EN: I notice that the label…
hello
I have a question about UCC27511-Q1
1,How many is the minimum pulse width? 2,How many is the maximum pulse width? 3,Is it subject to restrictions of a duty?
Thank you.
Part Number: TPS92561 Other Parts Discussed in Thread: TPS92515 I have following the below mentioned Led control Application for Machine Vision: used TPS92561 and TPS92515 Boost and buck controller.
Link: https://e2e.ti.com/blogs_/b/industrial_strength…
Hi Tom i am also trying to use the inhibit pin with the ptr08100 and the ptr08060. I want to use a tactile switch to control the output. My input is 8.4v (lithuim batteries) and obviously draining. I am using a potentiometer to give output from 3.61-5…
