Part Number: UCC27511 Other Parts Discussed in Thread: UCC28180 , Hi TI,
Should external gate resistance be used between the controller (UCC28180) and the gate driver (UCC27511)? What is the purpose used?
http://www.ti.com/lit/df/tidrls7/tidrls7.pdf
Part Number: UCC27511 Hi Guys
Our customer is using our UCC27511 as low side mosfet drivers. But about the system test, we found sometimes there is -2.4V at OUTL pin.
Please see below waveform:
CH4: Pin3 to GND. you can see there is -2.4V between pin3…
Part Number: UCC27511 I am designing a boost converter. But I am unable to confirm the inductance value. I referred several datasheets showing different equations so I am confused. Please help me to get correct inductance value, gate resistor value and…
Part Number: UCC27511
Hi all,
For LLC 300W 24V output iso DCDC, I want to use UCC27511 to dirive GaN(0to6V gate drive).
Please check the attached pdf cct.
Does it work?
Any concern?
Part Number: UCC27511 I am using UCC27511 single channel gate driver to drive 700W LED module (Output Voltage 375 to 390). We are implementing non inverting driver configuration as in application note (Fig 25 in datasheet) to drive mosfet PSM20N60CT.…
Part Number: UCC27511 Hello,
Can I tie the OUTH and OUTL output pins of the UCC27511 MOSFET driver if I do not need to use different speeds (resistors) for MOSFET turn on and trun off.
Best regards
Buddika
Part Number: UCC27511 Hello everyone,
currently, we implemented the driver UCC27511 to drive IGBTs with high pulse currents. To avoid parasitic turn-on, the OUTL gate resistor has a very small value - but still high enough not to exceed the maximum current…