Part Number: UCC27524 Customer would like to understand whether there are any requirements EN and VDD relationship. Can they use higher voltage for EN than VDD? Surely both EN and VDD are within 18V.
Could you please help check it? Thank you.
Part Number: UCC27524
Hi
We have a product design UCC27524.
We use electric meter (diode position)to measure the pin2 voltage . See the picture as attached.
We can measure some components exist 0.8V and some components doen't exist any measurement…
Part Number: UCC27524 Other Parts Discussed in Thread: UCC27288 , UCC27282 , UCC27284 Dear Team,
Here is Kevin from Delta Taiwan.
Customer is looking for TI device to replace IR2085STRPBF
infineon.com/dgdl/Infineon-IR2085S-DS-v01_02-EN.pdf?fileId…
Part Number: UCC27524 Hi,
in the datasheet we show that we have 400kohm pull down resistor from INA and INB to GND.
But I've measured the resistor with a multimeter, it's 8.2Mohm, not 400kohm.
Why?
Part Number: UCC27524 Other Parts Discussed in Thread: UCC28070 Hello Team,
This is regarding UCC27524 Driver failure.
We are driving two parallel mosfet using this driver.
Issue is Driver is failed(op short to GND) during load condition.
Without…
Part Number: UCC27524 Other Parts Discussed in Thread: UCC27424 Hi,
Can UCC27524 drive both the outputs simultaneously?
Datasheet says that IC can avoid shoot through..
Part Number: UCC27524 Driving waveform and schematic diagram, the MOS tube d-s voltage has obvious oscillation in the switching process, what may be the cause?
CH1:VDS CH2:VGS
Hi Li, Gang,
Just to follow up, all our drivers models are for Simetrix so they will not work in Simplis.
Is there a reason restricting you to use Simplis for your simulation?
Please let me know if you require further assistance or press the…
Part Number: UCC27524 Hi Team,
please kindly check below questions.
1. customer use short gnd line to test the voltage stress and find there is -4V/1.22ns spike. Please kindly check if it is OK.
Test point is as in red circle.
2. in datasheet…
