Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: UCC27537 Tool/software: Hello all,
In our projects, we plan to use UCC27537DBVR driver IC for the Mosfet BSC123N08. We used 5020YM IC driver before and now we would like to replace your products.
For a better understanding, I will attach…
Part Number: UCC27537 Hi Team,
I want to confirm if there is any small package of UCC27537 will be pushed such as DYY, DDF, DDC... And could you share the small package information and RTM time if we have. Thanks.
Best Regards,
Ryker
Part Number: UCC27537 Hello
I would like to understand the meaning of TON and TOFF in sluaap4.
Does it include the delay time and rise time?
Thanks in advance!
Part Number: UCC27537 Other Parts Discussed in Thread: UCC27517A , LMG1210 Hello
Some MOSFET has drive source and power source. How do I connect the driver with the MOSFET.
Like Infineon IPDQ60R010S7, the part has power source and drive source.
Normally…
Part Number: UCC27537
Hi team,
my customer use this on EV charging relay switch.
would you help check if this MOSFET is the right fit?
and check if the schematic has anything wrong?
Part Number: UCC27537 Hi,
My customer is evaluating UCC27537 and have some concern about the Input signal threshold. From the table we can see the Vin_H(min) = 1.8 V and Vin_L(max)=1.2V. So in the worst case the input signal hysteresis is only about…
Part Number: UCC27537
Hi, TI expert.
I have a question about EN pin of UCC27537.
Do you connect EN pin high to VDD?
Or should I just leave the EN pin floating?
For reference, VDD is expected to use 18V.
Please Check. Thank you.
Part Number: UCC27537 Other Parts Discussed in Thread: UCC27523 Hi team,
My customer is using UCC27537. The schematic is as below: VDD=12V, EN is floating and IN+ is from a opto-coupler.
We found that:
1. When we remove R6 and measure opto-coupler output…
Part Number: UCC27537 This is my first time working with Altium and TI parts. I'm having trouble figuring out how to import the part into Altium and run a simulation on it. Any help of this topic would be appreciated.
