Part Number: UCC27712 Hello
I would like to outpuwat a chopper wavehorm using the UCC27712.
Is it possible to obtain an output waveform like the one shown in the diagram below?
Please let me know if there are any problems.
Thank you.
Part Number: UCC27712-Q1 Other Parts Discussed in Thread: UCC27712 Tool/software: Hi,
Can you clarify the following timing parameters?
t PDRM Low-to-high delay matching
t PDFM High-to-low delay matching
What is the significance of these parameters…
Part Number: UCC27712-Q1 Other Parts Discussed in Thread: UCC27734-Q1
Hi team,
Is there a P2P replacement device for UCC27712-Q1, if yes, please specify the parameter & external circuit difference. Thanks
BR,
Daniel
Part Number: UCC27712 The datasheet says that the " outputs are held low when inputs are floating ". This implies they are actively held low. At what minimum power supply voltage does the UCC27712 start to actively hold the MOSFET outputs low?
In this…
Part Number: UCC27712 Tool/software: Hello,
I have used UCC27712 as full bridge driver circuit with external transistors that are based on PWM switching.
I am currently looking for a solution to drive the brushed DC motor with same setup, but different…
Part Number: UCC27712
Tool/software:
Hello,
Is there a reference design where UCC27712 gate drivers are used to drive 100% duty cycle on both high and low side of transistors? I understand it needs a floating power supply to bias high side transistors…
Part Number: UCC27712 Tool/software: Hello,
I am using the UCC27712 gate driver in a half-bridge configuration with Infineon IMTA65R033M2H SiC MOSFETs . In the datasheet I see two pieces of information about the VDD supply voltage:
In the Recommended…
Part Number: LM5116 Other Parts Discussed in Thread: UCC27712 , LM5146 , LM5137 , LM5119 Hi TI Team,
I am currently designing a synchronous buck converter using the LM5116 buck controller combined with the UCC27712 half-bridge gate driver for a high…
Part Number: UCC27712 During the compressor control system testing using the UCC27712QDRQ1 driver chip, it was found that two chips failed during repeated load-start tests (one with an upper bridge failure, and one with a lower bridge failure). The fault…
