Part Number: UCC3808A-1 Other Parts Discussed in Thread: UCC28951 , UCC28251 Tool/software: Hi. Can you please tell me... can the UCC3808A-1 chip be used in a push-pull topology to obtain a multi-channel voltage source with a power of up to 500 W in 24V…
Part Number: UCC38083 Other Parts Discussed in Thread: UCC3808A-1 I am currently trying to Design a feedback control loop for a switching power supply design using the UCC38083 and the UCC3808A-1. I am trying to bread board them before laying out a PCB…
Part Number: UCC3808A-1 Other Parts Discussed in Thread: UCC25600 , UCC38083 Hello!
I'm looking for a "voltage mode" controller in "8 pin solution" push pull configuration for half bridge smps but "not LLC" like ucc25600. I not found this controller…
Part Number: UCC3808A-1
Hi Ti,
Could you tell me why the deadtime showing in Figure 5 in Page 7 is different with that in Figure 13 in Page 13 in the below datasheet. Thanks a lot.
http://www.ti.com.cn/cn/lit/ds/symlink/ucc3808a-1.pdf
Best Regards…
Part Number: UCC3808A-1 Hello everyone, I am desiging with a Push pull topology a 500W DC-DC converter (Vin=24V +- 10%, Vout=200 V at 100 kHz). The current mode controller IC tha I am using is the UCC3808A-1.
The design (I followed Mclyman procedure…
Part Number: UCC3808A-2 Other Parts Discussed in Thread: TL431 Tool/software: Hello:
We are designing with the UCC3808A-2 for proto. We are aware that this part will be obsoleted and replaced by a similar pat with different marking.
Will the new part…
Part Number: UCC3808A-2 Dear Expert
End customer take another good D/C compare to current failure 4 D/C, we bought these D/C all has the same problem but the new D/C no any issue.
See below detail test report, hope u can check these 4 D/C 's problem…
Hi illia and Katlynne,
Thank you for the swift reply.
I have further inquiry;
1) The supply voltage of the proposed digpot IC is 2.7 - 5.5V. I need digpot IC that operates on 1.8V - 5.5V to allow me to supply 1.8V- 2V maximum to the IC, this…
Part Number: UCC3808A-2 Hello everyone,
I would like to know the implications of the Current Sense Gain value (2.2 V/V) of the UCC3808A2 ( http://www.ti.com/lit/ds/symlink/ucc3808a-2.pdf ) in the control loop. Particullarty, let's consider the following…
Part Number: UCC3808A-2 Hello,
I am measuring the output voltage through a little sample of the it (voltage divider), and then a isolated Oamp is connected. I would like to know if what I am doing is right:
The UCC3808A-2 has particularly 2 pins to…
