Part Number: UCD3138FW-HSFB Other Parts Discussed in Thread: UCD3138 Hello. I want to use UCD3138 to make a phase-shifted full-bridge circuit. I see that the development board uses voltage and current dual-loop control. Can UCD3138 achieve single-loop…
Part Number: UCD3138FW-HSFB Other Parts Discussed in Thread: UCD3138 Based on UCD3138, a full-bridge hard-switching power supply was used to test the waveform of the primary winding of the transformer.
Some of them are normal, and some of them appear…
Part Number: UCD3138FW-HSFB Other Parts Discussed in Thread: UCD3138 According to the UCD3138 full-bridge hard-switch development board, four full-bridge hard-switching power supply prototypes were made.
The input Vin: 20V~50V, no-load test.
When…
Part Number: UCD3138HSFBEVM-029 Other Parts Discussed in Thread: UCD3138FW-HSFB Tool/software: Hello TI team,
I am working on a design based on the UCD3138HSFBEVM-029. I need to download the complete design package **SLUC610** (schematic, Altium project…
Hello Liu,
You will still need to set a value within the period that EVENT2 and EVENT3 will occur. The UCD3138FW-HSFB , UCD3138FW-PSFB and UCD3138FW-BIDI all utilize normal mode. Below is the DPWM0 initialization for UCD3138FW-BIDI , which is based…
Part Number: UCD3138HSFBEVM-029 Other Parts Discussed in Thread: UCD3138 , UCD3138FW-HSFB , Hello,
Recently, we received two UCD3138HSFBEVM-029 modules. We connected an input of 48Vdc but we didn’t obtain the 12Vdc at the output. It seemed that the…
HI,Sean,
I first used my own code.It has the problem.then I tried TI EVM code, UCD3138FW-HSFB — UCD3138 Hard Switch Full Bridge.I downloaded form hear UCD3138FW-HSFB 固件 | TI.com.cn ( www.ti.com.cn/.../UCD3138FW-HSFB),The problem is the same.
Hello,
If the device cannot be found in ROM mode, neither in flash mode, then please go with a new one since there's nothing we can do.
There's firmware for HSFB, which is available here: https://www.ti.com/tool/UCD3138FW-HSFB
UCD3138 firmware is…
Dear Expert
I use CCS10.31 version, and the ARM compilier Tool version is 5.2.9
I downloaded the fixed SDK from TI webpage: UCD3138FW-HSFB — UCD3138 硬开关全桥, https://www.ti.com.cn/tool/cn/UCD3138_FW_SDK
and then I built workspace, and import this…
Hi Sean,
Most of our reference designs have firmware code derived from the EVM we publish. You can use our Hard-switching Full bridge code and modify to use on this reference design.
https://www.ti.com/tool/UCD3138FW-HSFB
Regards,
Sanatan
