Other Parts Discussed in Thread: UCD7231 I was wondering if you can help , with some additional info regarding the thermal performance of the Texas Instruments' UCD7231.
We want to use this gate driver in an area that has no significant airflow.
Our…
Other Parts Discussed in Thread: UCD7231 I have inherited a design that uses a pair of UCD7231 components to run an H-Bridge for a current controller. The design has some strange anomalies that I'd like to experiment with in Spice (TINA, full version…
Other Parts Discussed in Thread: UCD7231 , UCD9220 Question1 :
I had reflect of UCD7231 application circuit which possible of boost convertor from reverse think of buck convertor circuit .
I mean If when I think that exchange to input and output, Is It applicable…
The UCD7232 was an improvement of the UCD7231 allowing it to smoothly drive very low gate charge mosfets like the NexFets offered by TI .
It would be the preferred choice moving forward, but the UCD7231 will continue being offered for customers who have…
Part Number: UCD3138 Other Parts Discussed in Thread: UCD9240 , UCD90120 , UCD7231 , TPS40400
Hi Amiel,
With your help, I could have a PMBUS custimized GUI that could be able to communicate UCD3138 device.
But one proplem is that scan device in flash mode…
Other Parts Discussed in Thread: UCD7231 All,
We found problem on UCD7231, CSN and CSN of UCD7231 short to GND. just would like to check with TI, without the R SH_Sense could affect VGG, CSP, CSN short to GND or not. now we do not a resistor from HS se…
Part Number: UCD9248 Other Parts Discussed in Thread: UCD7230 , UCD7231
Is it possible to use ucd9248 along with PTD08A10W ?
this module is using ucd7230 gate driver and in the data sheet recommended driver ic is for ucd9248 is ucd7231, i think it should…
Part Number: UCD90120A Other Parts Discussed in Thread: UCD9240 , UCD90120 , UCD7231 I am using the UCD90120A with the UCD90SEQ64EVM-650 evaluation module.
I want to access it using API (I have downloaded ver. 3.0.8).
Is TIDP.PMBus.Parts.UCD9xxx correct…
These settings will depend on the method of current sensing which varies between the TI UCD drivers/powerstages.
The quoted values apply to rails using the UCD7231/7132 and any UCD PowerStage devices which incorporate this driver.
What are you using…
Other Parts Discussed in Thread: UCD9248 , UCD9224 , UCD7231 , UCD7242 Dear all I use the UCD9224/UCD9248 chip, and I see the datasheet that mention the UCD924/UCD9248 can generate min 15.26Khz(switching frequency) PWM signal. The datasheets also mention that…
