Part Number: UCD9081 Other Parts Discussed in Thread: USB-TO-GPIO2 1) Is UCD9081 Part only supports with USB-TO-GPIO2 debugger or we can configure using STM32 I2C ? If so,
2) We are tried to configure the UCD9081 with STM32 & Facing issues as below…
Part Number: UCD9081 Hi , our hardware team requires the use of ucd9081 devices to monitor vcc sensor values. Could you please provide driver support for these devices ( https://github.com/torvalds/linux/tree/master/drivers/hwmon/pmbus) ? Alternatively…
Part Number: UCD9081 Hi all,
I wanted to know if it's possible to trigger a controlled sequential shutdown, I.E. En8->En7...->En1 power-off using the GPIO pins on this IC. It doesn't seem possible since the GPIO has limited functionality. I'm already…
Part Number: UCD9081 Other Parts Discussed in Thread: UCD9080 On UCD9080/81 Power Control Sequence configuration software, the UV/OV Threshold control is greyed out. How do I get this to be enabled?
Part Number: UCD9081 Tool/software: We are currently working on Schematic design using the 10CX220YU484I6G FPGA.
We are planning to use the UCD9081 power sequencer for the FPGA supply. We would greatly appreciate your expert recommendations on the power…
Part Number: UCD9081 I am using the UCD9081 EVK to validate power sequencing for a new FPGA-based board design. The target system has a strict requirement that all power rails must power down in sequence within 100 ms .
In my final application, the…
Part Number: UCD9081 The UCD9081 datasheet specifies a minimum SCL clock frequency (f_SCL) of 10 kHz. I have an FPGA connected to the UCD9081 and am trying to use JTAG boundary scan to drive the I2C interface to the UCD9081 for initial programming. Due…
Part Number: UCD9081 Hi team,
We used TI's UCD9081 EVM GUI tool to do UCD9081RHBT_ PWER SEQ IC FW Burn.
But Power Sequence IC can't work after used our FW Burn fixture is System General (SG) SG8000.
We try 2 way as below show,
1. Used our FW code…
Part Number: UCD9081 Hi,
Actually, We are trying to Program the UCD9081RHBR device. We have two different data files (.Hex).
With the first file, I am able to program the device successfully, and the programmed data reads back correctly.
However…
