Hi Jingzhan,
We have tested this in the lab and we were able to bring up the ADC EVM in the WaveVision software without errors. One thing we did notice was that the clock and power must be provided before launching WaveVision.
The steps that we followed…
Dear Jim
Thank you for your reply.
I confirmed the manual of WAVEVISION5, but I couldn't find the description of ADC10080EVAL.
So could I confirm again.
Is it possible to connect between WAVEVSN-BRD-5.1 and ADC10080EVAL?
Best regards,
Shinic…
Hi Wei
I also tried testing with lower clock frequencies.
The lowest clock frequency I have successfully captured data at is 120 MHz. I think there is a limitation in either the FPGA data capture firmware, or the EVM clock path that is preventing captures…
Hi, I have a legacy High Speed Digital Interface Board Version 4.4 (ACTIVE) WAVEVSN-BRD-4.4 which I would like to keep using but not sure if it is any good for the newer or older 10-100 Msps ADS and DAC boards. There are several A/D and D/A boards listed…
Hi Fred
If you plan to evaluate the ADC16DV160 performance you need the following 2 boards:
ADC16DV160HFEB
WAVEVSN-BRD-5.1
The ADC and evaluation tools were developed before National Semiconductor became part of TI, and are not compatible with the TSW1405EVM…
Other Parts Discussed in Thread: ADC14155 Hi all: I am using the ADC14155LFEB/NOPB in conjunction with the WAVEVSN BRD 5.1/NOPB interfacing card. I want to do some RF testing with this set up, but I first need to know what the maximum input power of the ADC…
The Wavevision 5 board documentation (schematic, BOM, etc.) can be found on its product page:
www.ti.com/.../WAVEVSN-BRD-5.1 5 data capture board&tisearch=Search-EN-Everything
I have sent you a friend request. Please respond to that for information…
Hi Jim,
Thank you for your support.
Could you let me know whether ADC10080EVAL is supported by WAVEVSN-BRD-4.4, please?
At current status, Should we use WAVEVSN-BRD-4.4 at using ADC10080EVAL?
Best regards,
Shimizu
