Part Number: WILINK8-WIFI-MCP8 Tool/software: Dear support , I paid attention to that Intelligraphics information is no more available and what is the current status, and any 3rd party will continue such service ?
"3rd part 'Intelligraphics' provides 802…
Part Number: WILINK8-WIFI-NLCP Hello E2E Experts,
Good day.
Is it possible to switch the driver in half-duplex mode, so the first RF chain is RX only, and the second is TX only?
I have looked through https://www.ti.com/lit/ug/swru561a/swru561a.pdf?ts=…
Part Number: WILINK8-WIFI-NLCP
Hello E2E,
Is the WiLink8 Wi-Fi module supports Linux Kernel 5.x.x? Based on this User's Guide , it only contains patches of kernel version 4.19.38.
Regards, Carlo
Part Number: WL1831MOD Other Parts Discussed in Thread: AM67A , , CC3301 , WILINK8-WIFI-NLCP Tool/software: Hi,
We plan to use the AM67A processor with the WL1831MOD WiFi chip to support WiFi synchronization (the CC3301 wifi chip does not support any WiF…
Part Number: WILINK8-WIFI-NLCP Other Parts Discussed in Thread: WL1801 , WL1835 Hi,
1. Does Wilink8 mesh package support Non-TI platform with linux OS?
If so. Any limitation??
2. Does Wilink8 mesh work well with ALL wilink8 model? Can mesh work with single…
Part Number: WL1835MOD Team,
-Will the WL183x R8.8 SW support included by default in the next Sitara Linux Processor SDK? or do you always need to manually add it using the instruction provided in the UG SWRU561A?
-The BT stack has been certified against…
Part Number: WILINK8-WIFI-NLCP Hi Expert,
Could you help to check if WILINK8-WIFI-NLCP software can be download from TI.com. I can't find the download entrance, thanks.
Link: http://www.ti.com.cn/tool/cn/WILINK8-WIFI-NLCP?keyMatch=WILINK8-WIFI-NLCP …
Part Number: WILINK8-WIFI-NLCP hi,
we set WL8 be AP mode.
wl8 driver R8.7_SP3
wl8 fw version 8.9.0.0.81
Test Case:
DUT enable WL8 be AP mode.
Client connected to WL8 AP mode.
then Client device disconnected after few hours. the issue is random.
And …
Part Number: WILINK8-WIFI-NLCP Other Parts Discussed in Thread: WL1831 , WL1833 Hi,
Is there any way to read a special register (using calibrator + wl18xx_plt phy_reg_read <addr> ….) to identify the chip capabilities(ex WL1831 and WL1833) or if anything…