Kiran,
For #1, you can do a quick verification with the KC705 if you have the TSW14J10EVM. This will allow you to operate the TI HSDC Pro software and provide working firmware. See attached TSW14J10EVM User's Guide for more info regarding this setup…
4375.SLAU580B.pdf Diverger,
The Xilinx firmware developed to be used with the TI ADC34J43EVM, a TSW14J10EVM, a Xilinx FPGA development board and the TI HSDC Pro GUI required a second clock (core clock). This clock was to be provided by the mezzanine…
Jim,
Thank you for the replay I was following KCU105 HSDC Pro User's Guide.pdf , is there a way to make a common IP address between the host computer and KCU105 board without the need for switch or router.
Regards,
Ahmed
Imran,
I am not sure what a ZC702 board is but we have tested both our DAC38J84EVM and DAC38RF82EVM with a ZC706. We use a TSW14J10EVM, also from TI, to allow us to run our HSDC Pro GUI on the Xilinx platform. See the attached document for more information…
1030.KCU105 HSDC Pro User's Guide.pdf Takashi,
This EVM will plug directly into the KCU105. We have not tested these two together but we have tested other ADC EVM's that are using the same FMC connector and pinout as the ADS54J54.
Regards,
Jim
Tobias,
Are you using the TSW14J10EVM to interface to the Xilinx board? What Xilinx board are you using? If you are running the firmware from TI, the clock rates for the FPGA calculations are shown in the attached User's Guide on page 15. For your other…
Zhipeng,
I was able to get the DAC running with no issues using numbers close to yours with a VC707 platform. See attached file for info regarding this. May you have to consult with Xilinx if you are still having problems. I have also attached another…
Hello,
You can plug the ADS54J66 directly into a ZC706. We have not tried this but have tested similar ADC's with the ZC706 using the TSW14J10EVM interposer board. See the attached User's Guide for more information regarding this.
Regards,
Jim …
Harold,
What mode will you be using the ADC12J1600 in? I ask since the KC705 only has 4 JESD lanes routed and will not work if you are planning on using 8 lanes. Please see the attached TSW14J10EVM User's Guide for more information regarding using Xilinx…
