Part Number: ADS112U04 Other Parts Discussed in Thread: ADS122U04 Hii Bob,
I have four sensors & I want to read data from all four single-ended channels at a time.
presently I'm able to read one channel data.
Following are the commands which I…
Thanks Bob. I just got to know the microcontroller which I'm using operates in the –40 to +105 °C temperature range, so now it doesn't matter how ADS112U04/LM94022 behaves below -40°C as micro functioning is not guaranteed at this temperature…
Part Number: ADS112U04 Other Parts Discussed in Thread: AMC1100 , AMC3330 Hi team,
I'm trying to measure 50/60 Hz AC main voltage with ADS112U04.
AMC1100 should be used for isolated amp. I think 2kSPS is enough for measurement.
UART communication feature…
Part Number: ADS112U04 I'm using this IC for adc conversion in automatic mode. Set of command i send is (0x55 ,0x06, 0x55 ,0x40,0x81, 0x55,0x46,0x01)
and for reading the set register command value 0x26.
but i'm not receiving any data from ads112u04…
Part Number: ADS112U04 Hi team.
I'd like to know about the sampling rate.
This device has 2kSPS in turbo mode. However, it has 4 channels.
Is this sampling rate for all channels? or Is it 2kSPS divided by 4 channels?
Sincerely.
Kengo.
…
Part Number: ADS112U04 According to datasheet Section 8.5.3 Commands data are always transmitted byte-wise LSB first on the ADS112U04. So for ex to send SYNC(0x55) word, do I need to send (0101 0101) or (1010 1010) from micro controller?
Part Number: ADS112U04 Other Parts Discussed in Thread: ADS124S08 , I'm using K-type thermocouple to measure temperature which connected between AIN0 and AIN1 of ADS112. Section 9.2.1.2 Detailed Design Procedure in datasheet describes algorithm that…
Part Number: ADS112U04
I want to convert digital code(data coming out from ADS112) to temperature. I have gone through section 8.3.10 Temperature Sensor in datasheet, but it's little confusing.
So for example, I receive 55 AA (LSB first)data from…
Part Number: ADS112U04
Hello,
I've got a problem to write to the configuration registers of the ADS112U04.
I want to write the configuration registers of the ADC after the reset. If I read the registers directly after writing, the written values…
Part Number: ADS112U04 I'm writing a driver to cyclically read multiple channels from an ADS112U04, and I have a question on the communication timing limits for writing sequential WREG/ START commands.
In my application, I'm using an external analog…