Other Parts Discussed in Thread: ADS130E08
Forking this post into it's own thread.. Here's the recap
Jon Mundall Wrote:
On another note we had issues with our ADS131e08 's burning out when over saturating the inputs while running at a high gain…
Hello,
In our design we use a sensor board with a LP filters at 800Hz.
On the ADS131E08EV-PDK i saw an anti-aliasing filter(10k and 470pF) for 33,86kHz.
So if we already use a LP filter on 800Hz, did we also need this anti-aliasing filter?
If…
Other Parts Discussed in Thread: ADS131E08 , ADS131E06 , ADS131E08S Dear all,
I have two daisy chained ADS131E08 converters. Both are powered single supply, AVSS is GND and AVDD is 3.3 volts. My reference voltage is 3 Volts, nref is also connected to…
Other Parts Discussed in Thread: ADS131E08 , MSP430F2619 Hi TI Team,
We are in the process of development of a Circuit which measures AC Voltage and AC Current using MSP430F2619 and ADS131E08.
We have been able to interface with SPI very successfully…
Other Parts Discussed in Thread: ADS131E08 , TMS320F28027 , AMC1100 Hi,
On the TI site I've found link to the " Smart Metering Solution " - http://www.ti.com/ww/en/more/solutions/smart-metering.shtml . In the solution it is proposed to use ADS131E08…
Other Parts Discussed in Thread: ADS131E08 Hello,
Is there a difference between the Software Reset command and the Reset Pin. I use several ADS131E08 parallel. Sometimes if I power the device one of the ADS131E08 don't react. All the ADS131E08 get…
Other Parts Discussed in Thread: ADS131E08 Hello,
in my application I need a ratiometric reference for the ADS131E08. Simplest would be to make a voltage divider (2 resistors) and connect the center of the two R's to VREFP and VREFN to AGND...
But…
Other Parts Discussed in Thread: ADS131E08 Hello,
While trying to interface with device ADS131E08 via SPI we are encountering a strange problem.
Right after power up we are sending an RREG SPI command to the device, to read one register at address…
Other Parts Discussed in Thread: ADS131E08 Hi Community!
I have some problem with ADS131E08. I use RDATAC mode and everything works fine. Comes DRDY signal, which runs SPI, reads the contents of prepared channels. As it should be, I get from SPI 27…
Other Parts Discussed in Thread: ADS131E08 Hi all,
I'm trying to understand the problem behind the erroneous read between 2 ads131e08 with different production code(2BAYDKW-G4: it works well, 39CCDLW-G4: it is able to read only the first 4 channell…
