Part Number: AWR2944EVM I use the "High End Corner Radar" sample and integrate our VX1000 driver. I facing at the moment problems with the EDMA Konfiguration.
For the LFDS Stream Support I add the EDMA0 in the project, but the EDMA initialisation failed…
Part Number: AWR2944EVM Hi,
our HW engineer has several questions regarding transfer of the EVM antenna design to our PCB.
Please reflect:
What are the allowed tolerances for the PCB manufacturer for the printed antennas?
Are there any special…
Part Number: AWR2944EVM Dear TI advisor,
I noticed that the gtrack algorithm was not used in the "high_end_corner_radar" project. May I ask how I can enable this algorithm in CCS?
Thank you very much
Best Regards
Xu
Part Number: AWR2944EVM Other Parts Discussed in Thread: SYSCONFIG Hi,
I build a new HW based on the awr2944evm board and the project HECR. I used radar_toolbox_3_20_00_04, CCS 12.8.1, sysconfig_1.23.0 , mmwave_mcuplus_sdk_04_07_00_01.
I want to add…
Part Number: AWR2944EVM Tool/software: about the Ti 2944 radar system, specifically regarding the availability of units featuring the latest design improvements for the Tx and Rx antennas. Could you please provide me with the following information:
…
Part Number: AWR2944EVM Hello Team,
I am using the AWR2944EVM for one of my projects. To bring up the board, I used the Out-of-Box Demo project from Radar Toolbox version 2.20.00.05 . I successfully built and flashed the project, and it is working as…
Part Number: AWR2944EVM Hi,
currently the UART that works against a vizualiser in HECR demo requires a bit rate of 3125000 bps, which is quite high. What is a reson for that?
I shifted it down to 921600 kbp and didn't see any drops.
Practically…
Part Number: AWR2944EVM Hi,
I'm trying to enable MIBSPIA interface that is based on HECR demo and is supposed to go towards FTDI.
For some reason I don't see any signals. Can you please check me:
I added MIBSPIA configuration to mss.syscfg:
…
Part Number: AWR2944EVM Other Parts Discussed in Thread: AWR2944 Tool/software: Dear TI advisor,
I downloaded the awr2944_oob_object_data_over_can_DDM.appimage to the AWR2499EVM as instructed by “AWR2944 OOB Object Over CAN Users Guide”, but there was…
Part Number: AWR2944EVM Tool/software: Hello E2E Experts,
Good day.
I want to use CAN for data transmission, but mcan_enableTransceiver is not configured. How should I configure it? Are there any relevant process references?
Regards,
TICSC
