• 

  yangkun xu

  • 4 days ago
  • Amplifiers
  • Amplifiers forum

  BOOSTXL-3PHGANINV: BOOSTXL-3PHGANINV: Is it possible to use NI LabVIEW to generate and feed PWMs into BOOSTXL-3PHGANINV (GaN inverter) without the launchPad?

  TI Thinks Resolved

  Part Number: BOOSTXL-3PHGANINV Hello team, Is it possible to use NI LabVIEW to generate and feed PWMs into BOOSTXL-3PHGANINV (GaN inverter) without the launchPad. I have a modified PWM scheme different from conventional PWM scheme. Thus, I consider...
• 

  yangkun xu

  • 27 days ago
  • Amplifiers
  • Amplifiers forum

  BOOSTXL-3PHGANINV: Can this evaluation module be used for dc/dc boost converter even though it has a dc-link capacitor?

  • Resolved

  Part Number: BOOSTXL - 3PHGANINV I have a question about the BOOSTXL - 3PHGANINV evaluation module
• 

  Sam Ref

  • 7 months ago
  • Amplifiers
  • Amplifiers forum

  BOOSTXL-3PHGANINV: Equivalent Diode Rectifier

  TI Thinks Resolved

  Part Number: BOOSTXL-3PHGANINV Hello, A GaN power switch can operate in the 1st quadrant or the 3rd quadrant if a control signal is given to that switch. That GaN switch can also operate in the 3rd quadrant without 0 control signal to the GaN if the...
• 

  Yanming Luo

  • 5 months ago
  • Amplifiers
  • Amplifiers forum

  RE: BOOSTXL-3PHGANINV: 3 Phase Motor winding configuration requirements

  You may refer to chapter 5.2 (Hardware Prerequisites) of InstaSPIN-FOC and InstaSPIN-MOTION User's Guide (Rev. H) ( http://www.ti.com/lit/ug/spruhj1h/spruhj1h.pdf ) to have a detailed description of this. 1. Set correct parameters based on the...
• 

  Sam Ref

  • 7 months ago
  • Amplifiers
  • Amplifiers forum

  BOOSTXL-3PHGANINV: Controlled Rectifier

  TI Thinks Resolved

  Part Number: BOOSTXL-3PHGANINV Hello, If we use a generator to create a 40V three phase AC voltage. Can we use BoostXL-3phGaNInv to rectify this to 48VDC? If so what is the expected ripple at the DC side? In that case we should be able to the output...
• 

  Yanming Luo

  • 5 months ago
  • C2000™ microcontrollers
  • C2000™ microcontrollers forum

  RE: CCS: 28379D and BOOSTXL-3PHGANINV：Problems of inverter output waveform（Level 1）

  The voltage waveform is right since SVPWM is used in this project and it is the phase to the neutral point voltage. You might find the SVPWM introduction in some textbooks. The waveform will be pure sinusoidal if you measure the line to line voltag...
• 

  makan sheer

  • 8 months ago
  • Amplifiers
  • Amplifiers forum

  BOOSTXL-3PHGANINV: BOOSTXL-3PHGANINV switching frequency

  • Resolved

  Part Number: BOOSTXL - 3PHGANINV Hello community I am working with BOOSTXL - 3PHGANINV and its provided
• 

  Guang Zhou

  • 6 months ago
  • Amplifiers
  • Amplifiers forum

  RE: BOOSTXL-3PHGANINV: DC Power supply for inverter

  Hi Taohid, If you want to run same basic setup as demonstrated in the user guide, virtually all common lab power supplies can be used. The setup up can be powered with anything that is 12V or higher, and can supply about 200mA or more. If you want...
• 

  RATIK MITTAL

  • 8 months ago
  • Code Composer Studio™
  • Code Composer Studio™ forum

  Compiler/BOOSTXL-3PHGANINV: BOOSTXL-3PHGANINV + TMS320F28069M Launchpad

  • Resolved

  Part Number: BOOSTXL - 3PHGANINV Tool/software: TI C/C++ Compiler Hi, I’m using BOOSTXL - 3phGaNInV
• 

  Guang Zhou

  • 7 months ago
  • Amplifiers
  • Amplifiers forum

  RE: BOOSTXL-3PHGANINV: Inverter Design

  Hi Sam, There is no real difference among the three. It is mostly format and paper work in order to comply with applicable company standards/requirements governing publishing reference designs and orderable hardware. Regards, Guang

Didn't find what you are looking for? Post a new question.

• Ask a new question