Part Number: BQ25121 Changing CD pin to low and activating HighZ mode.
Will this shutdown I2C?
If i pull CD to low in the middle of an I2C operation, will it cause a failure?
High Impedance mode is the lowest quiescent current state while operating…
Part Number: BQ25121 Hi,
My actions:
1. Unplug Battery
2 Plug it back.
3. System will not wake up.
My device will not turn on after I unplug battery (3.7V) and then plug back.
Only if i connect to external power (5V) , it wakes up.
Any…
Part Number: BQ25121 Hello, we are very happy with the BQ25121 however the package option tends to drive up PCB cost due to small clearances and need for very small in-pad vias. Is there another package option for this part planned in the future?
Part Number: BQ25121 At power on the SW output will be 2.5V by Default. However the main controller IC requires a minimum of 2.7V .
Is there any variant which can provide 3V or 3.3V at power on condition .
Other Parts Discussed in Thread: BQ25121 Hi. I have an odd situation where the BQ25121 (non A) would power itself up after the ship mode instruction would be given. When looking at the scope on the PMID pin I could see that the voltage would start rising…
Part Number: BQ25121 Other Parts Discussed in Thread: BQ25120 Hi Sir
Is there having BQ25121 I2C sample code for reference ? (e.g. I2C Initial ; Set Output Voltage ; LS/LDO Output ; LDO Output Voltage…)
Bogey
Part Number: BQ25121 I want to get a LDO voltage of 3.3V.
I am Writing to Register : 0x07h , Load Switch and LDO Control Register the value: 0xE4
But when i read it i get the value : 0xFC
when i looked in Bq battery management Studio, 0xFC writes…
Part Number: BQ25121 Hello
When Charging device, PMIC enters Fault state, reading 0xC1h (Fault) on register 0x0h.
Battery is charging but this error concerns me.
When i disconnect device from charger it exist fault state and shows : 0x03h .…
Part Number: BQ25121 Other Parts Discussed in Thread: BQ25120A Hi...
There was no PMID output of BQ25121 when capacitor more than 15uF was applied on PMID pin as an output capacitor.
So I tested EVM under these same conditions and same result was…
