Part Number: BQ27510EVM I got a BQ27510EVM and try to use GPOUT pin to control charger enable.
When I heating the external thermistor, the temperature reading is correct.
And the [CHG_INH] bit is set high when temperature over 45 degrees Celsius.
But the…
Shirish,
I have obtained the BQ27510EVM and connected our battery and the EV2400. Under Chemistry of BQStudio, I was expecting to be able to program in Chemistry number 5377 that was recommended by the CHEM_ID report for our battery, however I do not…
Hello,
Can someone please explain what is the purpose of the circuit from SCL and SDA pins to the connector? I can understand the need for the pull up resistors but not the rest.
Thanks,
Yuval
Part Number: BQ27510-G3 Other Parts Discussed in Thread: BQ27510EVM Hi Team, We found RemCap slightly decreased although AvgCurrent always shows 0 (no load) with BQ27510EVM + battery. RemCap decreased about 1mAh in 30 minutes. Is it a possible case for BQ27…
Hi,
I am trying to learn the chemistry of 2.4Ah Ultralife battery (P/N:UBBL19-C1).Since this battery doen't come under the list provided by the Ti ,I did the chemistry learning cycle.
After 1 day of learning process it shows the following error …
Other Parts Discussed in Thread: BQ27510EVM Hello,
I am having BQ27510EVM board and EV2300 interface.
I have connected Pack+ & Pack - of lithium ion battery ( Manufacturer :Ultralife, P/N: UBBL 19 -FL ) to bq27510EVM ,also the I2C connector.
i have gone…
Other Parts Discussed in Thread: BQEVSW , BQ27510EVM Greetings,
I am trying to communicate Evaluation Board bq27510EVM with bqEVSW.
I can read DataRAM registers' values successfully, but while trying to read DataFlash - values of all registers are 0…
Part Number: BQ27510 Other Parts Discussed in Thread: BQSTUDIO , GPCCHEM Dear All,
We used the BQStudio to get the ChemID for our Li-ion Battery, we are using the BQ27510EVM with EV4200 to gather the log as required on the document http://ti.com/lit/s…
Part Number: BQ27510-G2 Other Parts Discussed in Thread: BQEVSW , BQSTUDIO , BQ27510 , EV2400 , BQ27510EVM I wish to conduct a full reset of my bq27510-G2. However, when I send the RESET subcommand (0x0041, preceded by the control command), I still have 0…