Part Number: C2000-DIGITAL-CONTROL-LIBRARY Other Parts Discussed in Thread: SYSCONFIG , TMS320F280039C Dear Sir,
we want a PWM control logic show as below, when OC happens(using CMPSS), PWM off immediately; then when the current is below the OC Back,…
Part Number: C2000-DIGITAL-CONTROL-LIBRARY Hi,
In my digital power converter, I'm using DCL libraries. I use DCL_runPID_C4 and DCL_runClamp_C1 for anti-windup reset. I'm calling PID update function at every 100msec in order to tune it.
If I don…
Part Number: C2000-DIGITAL-CONTROL-LIBRARY
Hi,
I saw below sentence at DCL user's guide about disabling interrupts during parameter update and want to learn it further.
"The first such sub-structure contains a Shadow Parameter Set (SPS), which the…
Part Number: C2000-DIGITAL-CONTROL-LIBRARY Hello.
TI 28388 ControlCARD is in use.
Testing Ethernet with C2000 example.
CPU1 has an example of ethernet_c28x_config. The CM has an example of enet_lwip_udp.
My question is why the "udp_rx_callback" function…
Hello Ben,
Ben Qin said: Is there any other algorithm library that can support C2000 series chips to calculate MD5?
To my knowledge we don't have support for this algorithm in any C2000 library.
Ben Qin said: If the provided interface md5_process is…
Nitish,
Nitish kumar Sharma said: For this purpose does TI provides any high level logger.
TI does not provide this.
Let me check on if there are any recommendations for any third party, but there are none that I am aware about.
Thanks.
Part Number: PMP8740 Other Parts Discussed in Thread: UCD3138 Hello team,
We are working on development of charger. Can you kindly suggest digital controller part number with reference design for development of 2 kW charger with complete schematic.
Part Number: TMS320F28P650DK Other Parts Discussed in Thread: TIDM-DC-DC-BUCK , PMP41081 Hi,
I'm trying to control a 3MHz buck regulator. What are the limitations I can come across at this switching frequency?
The goal it to use peak current mode control…
Hi,
Silas Perry said: Again, the point where the processor stops its pulses is when i plug the power and ground lines in from the 8 pin header to the breadboard so the probe is connected and able to sense the power rail of the controller.
I must have missed…