Part Number: CC-ANTENNA-DK2 Hi TI experts,
I did a simulation of Board#11 using HFSS (according to the DXF found from https://e2e.ti.com/support/wireless-connectivity/bluetooth/f/bluetooth-forum/630896/cc-antenna-dk-rd-2-4-ghz-pcb-antenna-design-files…
Hi Pedrhom,
Thanks for your reply.
I have restricted the field of view with +/- 60 degrees and range to 0.75 in the CFAR configuration such that I get always get a single point in close range as per my application requirement.
I hope TI would pay attention…
Part Number: CC-ANTENNA-DK2 Hi TI Team,
The design note (page 4) mentions that only ANT2 and ANT3 are required for the PCB helical antenna. Is it okay to use ANT1, ANT2, and ANT3, and sometimes ANT1 and ANT2? (When tuning I found that these combinations…
Part Number: CC1310 Other Parts Discussed in Thread: CC-ANTENNA-DK2 Hi
I notice in the design note DN038 it says the antenna must be tuned differently for 915/920 MHz. We are looking for a variant for 915-928 MHz. (centered around 922MHz)
Is there any…
Hi,
There are two cable supplied with the CC-Antenna-DK2, JSC-JSC and JSC-SMA.
Measuring the antenna on a VNA should be done with the JSC-SMA cable supplied in the CC-Antenna-DK2 kit.
Regards,
Richard
Part Number: CC113L Other Parts Discussed in Thread: CC-ANTENNA-DK2
Hi,
I have a couple of questions about the CC113L and its antenna @433MHz. My plan is to use a wire antenna on the receiver side. Here are my questions:
1.What are the wire antenna requirements…
Part Number: CC115L Other Parts Discussed in Thread: CC-ANTENNA-DK2
Hello,
I have a couple of questions about the 433MHz antenna. In the attached photo, the left one is the TI 433MHz antenna (swrr081a) from the Gerber files of an EVM.
Now, my questions…
Hi Stephen,
The meander structure is quite easy to draw into a new layout.
Please use the design from CC-Antenna-DK2 #9 either by re-drawing the meander structure into your design or by importing the CC-Antenna-DK2 #9 gerber. Old reference design are sometimes…
Part Number: CC1352P Other Parts Discussed in Thread: CC1352R , CC-ANTENNA-DK2 , Dear Experts,
We thought to upgrade our cc1352r based device with cc1352-p1 for 20dbm here we have some doubts about Antenna design,
1. What is the use of SKY13317-373 RF switch…
Part Number: CC2640R2F Other Parts Discussed in Thread: CC-ANTENNA-DK2 , Hi,
From what I know the PCB Antenna at CC2640R2F Launchpad is the 2.4GHz inverted F Antenna. I am looking at the CC-ANTENNA-DK2 is the 2.4GHz inverted F Antenna Board 11 or Board 5…