Wojciech,
The attached v0.9.65 installer should have all the required files. I already tried to attach it as an exe, but it was rejected. So, the attached file has its extension changed from exe to txt. Just change it back and run it.
Regards, …
Hi Lin,
a) 12.1k bottom resistor and open on the top resistor for Msel1A, with the assumptions on Cout in excel, I am seeing a comp config of 13, but the bode at the bottom of excel shows 43deg phase margin and 43kHz cross over freq and Fsw is 550kHz…
Hi,
I get it, so you want to know how to connect MSP430 with debugger. You need to connect them together through JTAG(4 pin) or SBW(2 pin) and GND, 3V3.
The documents what you want. One tells you how to connect MSP430 with debugger. And another one…
Hello Tim,
I have attached the file you requested. I would still like to know how if once it has tripped out and the feedback voltage goes below the hysteresis low point it will not restart. Other than this problem the regulation is good and "tight…
Hi Tarun,
We are planning to implement the following diagnostics mentioned in TI's safety manual (SFFS462_J784S4_TDA4AP_TDA4VP_TDA4AH_TDA4VH_SafetyManual_v0.99.pdf):
e2e.ti.com/.../5315.SPRUJ52-_2D00_-J84S4-AM69A-TRM.pdf
• INTR1 - Software Read…
Part Number: TDA4VM Tool/software: Dear TI Support Team,
I am working with the TI TDA4 J784S4 SoC and referring to the attached SPRUJ52D Technical Reference Manual (TRM) . I need clarification on the interaction between the A72 core , the R5F firmware…
Part Number: WILINK-SW As stated in the linked thread:
I am using TI’s NL5500L Navilink GPS/BT/FM combo chip.
Host platform details :
Processor: OMAP-L138
Kernel: Linux 4.12.0
Bluetooth Stack: BlueZ 5.50
I was having trouble even connecting…
Part Number: BQ24079T
Hi,
I would like to know why BQ24079T NTC voltage has charging/non-charging status? The ambient air temperature from 45°C to 33°C.
The battery charging current has jitter situation. I/m not sure it cause by NTC voltage status…
Hi,
hongyao.jin said: 1.We would like to know what the differences are between this L3 MSMC MEM and L1 L2 MEM.
L1 Memory is the s mallest, fastest memory directly within each C7x core. It serves as the primary memory for instructions and data with…
Hi Mark, According to the TRM document that i am currently using ( SPRUJ52D – JUNE 2022 – REVISED JULY 2024, link ), I can only validate 2 CLKSEL signals; - WKUP_PER_CLKSEL (Table 5-35, Page 302) for WKUP_UART_0. Values are [19.2, 20, 24, 25, 26, 27]…
