Search tips
Showing 120 results View by: Thread Post Sort by

  • CC113L: CC113L does not receive any data

    Part Number: CC113L Tool/software: My customer met an issue during developing a program to interface with CC113L The read out from RXBYTES register(0x3B) is always 0. Would you please help check if there is anything missing from the configuration? …

  • CC113L: Keeloq receiver low range

    Part Number: CC113L Other Parts Discussed in Thread: TEST2 Tool/software: I'm using the CC113L with an own prototipe as a Keelog receiver for 868.35 MHz band. Following the design note DN022, a post in the forum about receiver for keelog and the Applications…
    • Answered

  • CC113L: CC113L/MSPM0

    Resolved
    Part Number: CC113L Hi, I'm currently working with CC113L+MSPM0. I have successfully received data from the transmitter in SmartRF, but unfortunately, I haven't received proper data from SPI. I have attached the analyzer screen herewith for your reference…
    • Resolved

  • CC113L: Request a set of configuration parameters

    TI Thinks Resolved
    Part Number: CC113L Other Parts Discussed in Thread: CC110L Tool/software: Hello My requirement: Based on the provided radio frequency parameters, request a screenshot of the configuration parameters on the Smartrf studio software and the exported parameters…

  • CC113L: The CC113L chip receives abnormal

    Part Number: CC113L Other Parts Discussed in Thread: CC115L hi Ti engineer Recently, one CC113L chip was found to be abnormal, which was mainly manifested as serious packet loss. The preliminary analysis showed that the chip had to wait for a long time…

  • CC113L: CC115L/CC113L

    TI Thinks Resolved
    Part Number: CC113L Other Parts Discussed in Thread: CC115L , , CC1310 HI All, I am currently working on communication between one of our legacy devices and the CC113L (RX) and CC115L (TX) modules. Initially, I connected the devices using CC Debugger…
    • Answered

  • CC113L: How to set the number of premble bytes

    Resolved
    Part Number: CC113L Tool/software: How to set the number of premble bytes? I didn't see this configuration in the register in the manual. Best regards, HuangChaoyu
    • Resolved

  • CC113L: How to trigger an interrupt when receiving variable-length packets without length byte in the first position?

    Part Number: CC113L Tool/software: Hello, I am working with the CC113L . My use case is the following: The RF frames I receive have different lengths . The length of the frame is not included in the first byte (so I cannot use the "variable…
    • Answered

  • CC113L: The eeset function of CC113L

    Resolved
    Part Number: CC113L Other Parts Discussed in Thread: CC1101 Hi, I have a question regarding the reset function of CC113L. When using our equipment, the correct data may not be output even if data is received. Since random signals are occurring at the…
    • Resolved

  • CC113L: Check waveform and teach us recover method for ESD failure mode

    Part Number: CC113L Tool/software: We have a question about the reset function of CC113L. During ESD testing of our product, a symptom occurred that RF signals could not be received. After checking the details, we found that immediately after ESD…

Didn't find what you are looking for? Post a new question.